Instructions / Assembly

LEGS & COVER ASSEMBLY

Inside View Outside View

1. Lift one side of canopy top and insert legs. Proceed to the other side.

2. Pull sides of tarp down and adjust until it ts equally on all sides.

Attach the remaining 4 (60”) pipes to the legs so the sidewalls can be secured. Pipes will t ush against the

bolts as seen below (Figure 1). Using the single clamps on the corners and the double clamps in the middle.

4. Place straps through grommets and around sidewall pipe as seen above (Figure 2). Sidewall pipe should

then be pulled down until the cover is pulled tight. Then the clamps may by tightened.

Insert rst

Insert second

Figure 1

Figure 2

CANOPY REMOVAL:

The best way to remove and fold the

cover would be to follow the exact

opposite of the installation process.

Detach all the ball bungees, unzip the

door, slide up the sides and fold them

over onto the roof. Disassemble your

structure by removing the legs from

one side and lowering it. Then you

could nish folding up your canopy

cover, put it o to the side and nish

taking down the structure.