Instructions / Assembly

ManualsBrandsKing Canopy ManualsStorage & OrganizationGarage 10 ft. W x 20 ft. D Dome Storage Garage

Dome Garage 10 ft x 20 ft

10 ft Wide x 20 ft Deep x

8 ft Center Height

King Canopy Item # G10208

With 10 Legs, 1 Piece Cover with Side Walls, 1 Zippered End Wall,

1 Solid End Wall, Elastic Ball Straps, Foot Pads and Anchors.

WARNING:

Keep all ame and heat sources

away from this tent fabric. Meets

the ammability requirements of

CPAI-84 Section 6 and NFPA-701.

It is not re proof. The fabric will burn if

left in continuous contact with

any ame source.

Distributed by:

PIC America, LTD.

1730 Five Points Lane • Fuquay-Varina, NC 27526

1-800-800-6296 • www.kingcanopy.com

Summary of content (10 pages)

PAGE 1
Dome Garage 10 ft x 20 ft 10 ft Wide x 20 ft Deep x 8 ft Center Height King Canopy Item # G10208 With 10 Legs, 1 Piece Cover with Side Walls, 1 Zippered End Wall, 1 Solid End Wall, Elastic Ball Straps, Foot Pads and Anchors. Distributed by: PIC America, LTD. 1730 Five Points Lane • Fuquay-Varina, NC 27526 1-800-800-6296 • www.kingcanopy.com WARNING: Keep all flame and heat sources away from this tent fabric. Meets the flammability requirements of CPAI-84 Section 6 and NFPA-701. It is not fire proof.
PAGE 2
PARTS LIST FOOT15PC-T (4) 2-way Corner Foot Pads FOOT15PC-X (6) 3-way Center Foot Pads 3W13PC-T (10) 3-way Connectors (ends) 4W13PC-X (15) 4-way Connectors (centers) 4X10-15PC (28) 58” Pipe 2X10-15PC (10) 21.
PAGE 3
FRAME ASSEMBLY For faster and easier set-up, we recommend assembly by two or more people. 1. Lay parts out as shown in Diagram A below. Note: The 58 inch straight pipe form the length of the frame. The 33.5 inch straight pipe are the legs that connect to the feet. 33.5´´ Straight Pipe 58´´ Straight Pipe All Horizonal Pipe Diagram A 3-way Connectors are for each end Note: Longest part of 3-way is used to form the length.
PAGE 4
FRAME ASSEMBLY Diagram C-1 3. After assembling the first full length section of roof, (See Diagram C-1) use the rope enclosed to hold frame together by tying frame from end to end down the center (See Diagram C-2). Diagram C-2 Diagram D 4. Continue assembly by completing the next curved section on each side of the top section. (See Diagram D) Hold frame together by tying frame from end to end at the bottom of this section as in Diagram C-1 above.
PAGE 5
COVER & LEGS ASSEMBLY Diagram F 6. Remove cover from plastic bag and unfold. Next fold half the cover over the other half with the white side out. Match the corners (See Diagram F) and mark the top center of cover at the grommet line at both ends. (See Diagram G). Diagram G 7. Once centers have been marked at both ends, pull cover over frame with white side down. (See Diagram H) Position the center mark with the top center pipe of frame.
PAGE 6
COVER & LEGS ASSEMBLY 8. Once you have secured top to curved section of frame, you may now finish frame assembly. Assemble the remaining frame on each side using the 33.5´´ pipe, foot sections, and 58´´ pipe as shown in Diagram K. Make sure hooks on the feet are on the inside of frame. Push in on leg sections and make sure the legs are securely set on ground before assembling final side and standing canopy up. This will keep the canopy from sliding. 9.
PAGE 7
COVER & LEGS ASSEMBLY Diagram N 11. To complete your canopy, secure the top down each side on the bottom pipe and around each end with ball straps. (See Diagram N) Diagram O 12. Add the canopy endwalls using the Velcro straps and then secure them using the ball straps. Next, tighten and secure the drawstrings at each corner foot. You have successfully set up your canopy (See Diagram O). Now that the canopy is set up, you may remove the ropes used for assembly. Diagram P 13.
PAGE 8
ANCHORING YOUR UNIT This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely anchored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not properly and securely anchored to the ground. Severe winds will cause the frame to twist and unanchored legs will fall, thereby collapsing the canopy. If severe winds are expected, you must remove the cover from the frame to prevent damage.
PAGE 9
IMPORTANT NOTICE: PLEASE READ CAREFULLY We are confident that you will be completely satisfied with your King Canopy unit. Please take a moment to read the very important information below, and call us with any questions you may have. King Canopy/PIC America, LTD. has no control over wind, snow, ice, rain or any other weather condition and we are in no way responsible for any damage caused by the canopy or to the canopy.
PAGE 10
PRODUCT INFORMATION Defective Parts We try our best to eliminate any defective parts that are shipped with our products. If, however, you should find a defective part, we will replace – free of charge – any part which is defective. You will need to provide proof of purchase showing date of purchase and provide us with detailed description of the defective component. Your replacement will be shipped by ground shipping, freight prepaid.