Instructions / Assembly

ManualsBrandsKing Canopy ManualsStorage & Organization9 ft. W x 14 ft. D Brown Storage Shed

Storage Garage 9 ft x 14 ft

9 ft 5 in Wide x 13 ft 11 in Deep x 5 ft 10 in Side Height /

8 ft Center Height

King Canopy Item # G0914-SB

With 6 Legs, 1 Pc. Cover, 1 Zippered Front Wall,

Elastic Ball Straps, Foot Pads and Stakes.

WARNING:

Keep all ame and heat sources

away from this tent fabric. It is not

re proof. The fabric will burn if

left in continuous contact with

any ame source.

Distributed by:

PIC America, LTD.

1730 Five Points Lane • Fuquay-Varina, NC 27526

1-800-800-6296 • www.kingcanopy.com

These Tools Are

Recommended:

Summary of content (7 pages)

PAGE 1
Storage Garage 9 ft x 14 ft 9 ft 5 in Wide x 13 ft 11 in Deep x 5 ft 10 in Side Height / 8 ft Center Height King Canopy Item # G0914-SB With 6 Legs, 1 Pc. Cover, 1 Zippered Front Wall, Elastic Ball Straps, Foot Pads and Stakes. These Tools Are Recommended: Distributed by: PIC America, LTD. 1730 Five Points Lane • Fuquay-Varina, NC 27526 1-800-800-6296 • www.kingcanopy.com WARNING: Keep all flame and heat sources away from this tent fabric. It is not fire proof.
PAGE 2
PARTS LIST 3X11-15PC (22) 47 Inch Pipe 3X2-15PC (10) 38 Inch Swedge Pipe 2X1-15PC (6) 25 Inch Swedge Pipe 3W16PC (6) 3-Way Fittings 4W16PC (3) 4-Way Fittings FOOT16PC-SL (6) Metal Foot Pads STAKE-GAR (12) Foot Pad Stakes T0914GF-GAR (1) Cover with Rear Wall & Side Walls T09GEWZF-GAR (1) Zippered Front Wall BALL (35) Elastic Ball Straps SC15 (4) Single Side Pipe Clamps w/ 2 Inch Bolts, Nuts & Washers DC15 (2) Double Side Pipe Clamps w/ 2 Inch Bolts, Nuts & Washers 16 - 1.
PAGE 3
ROOF FRAME ASSEMBLY Diagram A 1- Start assembly with top frame as shown in Diagram A. The 47 inch pipes are used for the roof rafters and 47 & 38 inch pipes form the length of frame. Start assembly with center peak as circled in Diagram A. 1.75 inch Bolts are included to bolt the pipes together for 47 Inch Pipe additional strength.
PAGE 4
COVER ASSEMBLY With frame assembled and cover on, you can now attach cover to frame using the ball straps. The grommet holes on the cover for attaching straps are located along the back and front frame line. Picture # 1 indicates where to find grommet holes. Attach the cover by running the strap through the grommet hole, around the pipe, then loop the strap over the ball. If the straps are too long for a tight fit, you can double wrap them or make an additional knot in the strap cord to shorten them.
PAGE 5
ANCHORING YOUR UNIT ANCHORS ARE NOT INCLUDED This canopy is designed for use as a temporary structure. After assembly, the canopy MUST BE securely anchored to the ground to prevent damage from winds. Your canopy will act like a kite in the wind if not properly and securely anchored to the ground. Severe winds will cause the frame to twist and unanchored legs will fall, thereby collapsing the canopy. If severe winds are expected, you must remove the cover from the frame to prevent damage.
PAGE 6
IMPORTANT NOTICE: PLEASE READ CAREFULLY We are confident that you will be completely satisfied with your King Canopy unit. Please take a moment to read the very important information below, and call us with any questions you may have. King Canopy/PIC America, LTD. has no control over wind, snow, ice, rain or any other weather condition and we are in no way responsible for any damage caused by the canopy or to the canopy.
PAGE 7
PRODUCT INFORMATION Defective Parts We try our best to eliminate any defective parts that are shipped with our products. If, however, you should find a defective part, we will replace – free of charge – any part which is defective. You will need to provide proof of purchase showing date of purchase and provide us with detailed description of the defective component. Your replacement will be shipped by ground shipping, freight prepaid.