Installation Guide

COVER ASSEMBLY

PICTURE-1

PICTURE-3

ATTACH BALL STRAPS

With frame assembled and cover on, you can now attach cover

to frame using the ball straps. The grommet holes on the cover

for attaching straps are located along the back and front frame

line. Picture # 1 indicates where to nd grommet holes. Attach

the cover by running the strap through the grommet hole,

around the pipe, then loop the strap over the ball. If the straps

are too long for a tight t, you can double wrap them or make an

additional knot in the strap cord to shorten them.

To install side rails and wall support, slide a 69 inch pipe into the

sleeves at the bottom of the side walls, as shown in picture # 2.

Use double side clamp to connect to center leg and single side

clamp to connect to corner legs. (See pictures below.)

Your storage shelter can be used with or without the front

zipped wall. If you choose to use your front wall, install it with

the velcro strips and ball straps through the grommet holes,

then attach it with velcro enclosures as seen in picture # 3. The

wall can be removed quickly and easily at anytime.The front wall

has a zippered door that rolls up to gain access and closes for

storage. The sides and ends are extra long and can be buried in

the ground or use rock, stone or brick over them to help keep

unwanted creatures out. (See pictures below.)

Corner leg

PICTURE-2

Center leg