User's Manual

©KINEXON 2019. This document is confidential and contains information which is proprietary to KINEXON GmbH. No reproduction
is permitted without prior express
written permission of the author ([e-mail]).
4
FCC COMPLIANCE
This device complies with 47 CFR Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved by the
party responsible for compliance could void the user’s authority to operate the
equipment.
This device may not be employed for the operation of toys. Operation onboard an
aircraft, a ship or a satellite is prohibited.
The use of this device mounted on outdoor structures, e.g., on the outside of a
building or on a telephone pole, or any fixed outdoors infrastructure is prohibit-
ed.
Note: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be de-
termined by turning the equipment off and on, the user is encouraged to try to cor-
rect the interference by one or more of the following measures:
▪ Reorient or relocate the receiving antenna.
▪ Increase the separation between the equipment and receiver.
▪ Connect the equipment to an outlet on a circuit different from that to which the
receiver is connected.
▪ Consult the dealer or an experienced radio/TV technician for help.
IMPORTANT NOTICE
This equipment may only be operated as a handheld device. Operation with fixed out-
door antennas is prohibited and could subject the operator to serious legal penal-
ties.
At any time, a minimum separation of 7 cm must be maintained from the operating de-
vice and any person or persons.
The KINEXON Receiver will only operate (i.e. transmit UWB signals) when activated
within a KINEXON network.
RF EXPOSURE NOTICE
This device is a radio transmitter and receiver. It is designed not to exceed the
limits for exposure to radio waves adopted by the FCC. These limits include a sub-
stantial safety margin design to assure the safety of all persons, regardless of
age and health. The radio wave exposure guidelines use a unit of measurement known
as the Specific Absorption Rate, or SAR. SAR levels have been computed for the
transmitters in this device and have been found to be below FCC limits.
SAFETY INFORMATION
▪ The device is intended to be supplied from a Limited Power Source (LPS) whose
power consumption should not exceed 40 VA and current rating of overcurrent pro-
tective device should not exceed 2.5 A.
▪ Read and follow all instructions before using the KINEXON Receiver.
▪ Never open the case of the KINEXON Receiver except for the battery compartment
and the cable compartment. There are no user serviceable parts or replaceable
parts inside the case.
▪ Do not use the KINEXON Receiver if it has been damaged.