User's Manual

©KINEXON 2019. This document is confidential and contains information which is proprietary to KINEXON GmbH. No reproduction
is permitted without prior express
written permission of the author ([e-mail]).
3
RECEIVER MOUNTING
Generally, there are two possibilities concern-
ing the environment in which the KINEXON re-
ceiver will be temporarily placed: Indoor or
outdoor. The receiver can be powered on and off
by pressing the power button. In indoor as well
as outdoor environments, the receiver will be
temporarily mounted on tripods etc.
REGULATORY AND LEGAL INFORMATION
The KINEXON Receiver has been designed to be in compliance with both the U.S. FCC
Part 15 subpart F regulations, sections 15.519 and 15.521 and with the European Un-
ion ETSI EN 302 065 standards. Two different versions of the KINEXON Receiver are
available, one version supports the FCC emissions mask (Region 1) and the second
supports the ETSI standard mask (Region 2).
DISCLAIMER
The information in this document is subject to change without notice. KINEXON GmbH
assumes no responsibility for inaccuracies or omissions and specifically disclaims
any liabilities, losses, or risks, personal or otherwise, incurred as a conse-
quence, directly or indirectly, of the use or application of any of the contents of
this document. For the latest documentation, contact KINEXON GmbH.
INTENDED USE
This manual describes the setup and use of the KINEXON Receiver. Use this product
only for the purpose it was designed for.
OPERATIONAL MODES
This product has two operational modes, non-charging and charging. Most functions
(especially affecting localization) are available in both modes. Please respect the
different allowed temperature ranges.
With no battery inserted, the device is always “non-charging” mode. This holds re-
gardless if powered by coaxial power plug, side contacts or PoE (Power over Ether-
net).
If the device has a battery inserted: The device is in “non-charging” mode if coax-
ial power plug and side contacts are unused. Connecting a supply to the coaxial
power plug or the side contacts will put the device in “charging” mode. Connecting
Ethernet or PoE (Power over Ethernet) does not affect the operational mode.