User's Manual

The current record
is Group 1.
The corresponding
time is 08:00 (a.m.).
The corresponding
date is January 1st.
Date and Time will display alternately.
Recall the Records
2.
3.
Press the button to switch the user ID between user and .
press the button or button to confirm the selected user ID.
1.
When the monitor is off, press the button, the LCD will display
the total groups of the memory records, with the user ID blinking.
Then the LCD will display the average value of last 3 readings. When
the records are less than three groups, it will display the latest record.
(Example shown below for User 1)
4.
Press the or button to display the next record.
Note
The latest record (1) is shown first. Each new measurement is
assigned to the first (1) record. All other records are pushed back one
digit (e.g., 2 becomes 3, and so on), and the last record (90) will be
dropped from the list.
During a measurement, if there is excessive body motion, especially of the
arm the cuff is worn, the symbol will flash about 5 seconds and detect
again. If it is no longer detected, the symbol will disappear; If still detected,
the symbol will final display in the measurement result.
Note
The measured blood pressure reading may not be accurate if this symbol
is displayed.
4.
Press the button to turn off the monitor, or it will shut off after
about 1 minute.
Note
Both user and can store maximum 90 groups of record. When you
pass that limit, every time you take the measurement, the monitor will
prompt “FULL” first and the oldest record will be dropped from the list after
the measurement.
5.
About the irregular heartbeat and excessive body motion during the
measurement.
During a measurement, If an irregular heartbeat is detected, the symbol
will display in the measurement result. See page 24 for more information.
1716
DATA MANAGEMENTMEASUREMENT