Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

5.2 Connectors

This chapter introduces specification and pin-out of some connector/ports on camera body and KineBACK-

W including DC IN, CTRL, EXT and TC.

5.2.1 DC IN

DC IN is on the lower right of camera body, a 1B 2-pin MOCO socket. The voltage

range for camera is 11V~19V, DO NOT use power source higher than 19V, or the

camera will be burned. Also, please note that:

 Max current of external power is 3A;

 Max consumption of camera body only is 25W;

 With KineMON, max consumption is 30W.

NOTE Red dot and groove on the socket should match pin #1.

5.2.2 CTRL

CTRL is on the lower front of the camera body, a 0B 4-pin MOCO socket.

 Shorten pin #1 and pin #3 can trigger on/off;

 Pin # 2 outputs 3.3V, max 1A. Pin #2 and #3 are for power supply;

 Pin #4 is reserved.

CAUTION The camera will shut down if the current through Pin #2 is higher than

1A.

5.2.3 EXT

EXT port is on KineBACK-W, a 1B 6-pin MOCO socket. It outputs 12V, max current

1A, or even outputs power from V-lock battery plate when a battery is attached.

Meanwhile, EXT port is also used to provide power and control to Movcam motor

for follow-focus (UM4).

CAUTION The camera will shut down if the current through Pin #4 is higher than

1A.

NOTE CAN_L and CAN_H are for the control of Movcam motor.

DC IN

1. DC IN as VDD

2. Ground

1. REC;

2. 3.3V output;

3. GND;

4. Reserved

1. Detect

2. CAN_L

3. CAN_H

4. 12V output

5. Battery output

6. GND