Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

 Restore to factory reset: [ConfigurationSystem Factory Reset], or power on the camera with a USB

thumb connected to USB port.

7. No audio when playback the clip

Please check if the project fps is the same with sensor fps, if not, the audio will not be packed into

ProRes mov, but be saved as two wave files to the clip folder. For details, see section 3.3 Slow-Mo

and Quick-Mo.

8. Iris of electronic EF lens cannot be adjusted:

 Make sure attach EF lens to EF mount in right way: please refer to Section 2.3 Quick Guide – Lens;

 Make sure that the Active EF mounting adapter is assembled well: please refer to 2.2 Mount. EF

mounting adapter will show the "ef sys" + version number at the bottom of the menu;

 Make sure the EF lens is compatible with Kine cameras: Whitelist for lens;

 Make sure the iris control enabled: [ConfigurationSettingsActive MountEnhanced]

9. There is no sound after inserting with XLR MIC of KineBACK-W:

 Make sure there is a good connection between XLR port and the MIC;

 Turn on KineAudio: press twice on Audio button or [ConfigurationAudioKineAudio: ON];

 Turn on Phantom 48V if using phantom powered MIC: press twice on Audio button or

[ConfigurationAudioPhantom 48V: ON]

10. Camera can not update with new firmware:

 Check whether [USB] shown in the UI after USB stick is inserted to the USB socket of camera, else

change another USB socket to try it;

 Check USB disk is FAT32, not NTFS nor HFS;

 Check if the firmware is stored at the root folder of USB disk, and no other firmware files in the same

place;

 Rebuild the USB disk as FAT applying MBR partition.

11. Black screen with a cross while switch between the codecs:

You don't have to reboot the camera when switching between codecs, but the screen will be black

with a cross in the center for a few seconds, this is not a failure or a bug.