Operation Manual

MAVO LF Operation Manual（KineOS 6.2）
©2019 Kinefinity Inc. Page 31 / 62
3.6.2 External TC
There are three kinds of frame rates when using external TC: Project FPS of
TERRA, Sensor FPS of TERRA and External FPS of TC generator. From KineOS
6.1, make sure that the Sensor FPS is an integral multiple of the External FPS.
Timecode on UI will be green if you successfully set the system. If there is no
external timecode feeding into the camera, it will automatically employ the
internal timecode of the camera and show Yellow. If the timecode blink
green/red/yellow, you need to check if there is:
 Improper settings on the frame rates
 Poor cable connection;
 Power loss of external timecode device;
 Special settings needed for the timecode device. For example,
NanoLockit TC output needs to be activated manually.
3.6.3 Beeper and SYNC
The beeper has two usages:
 It makes a tone of 1KHz and 2KHz respectively when trigger on/off
record, to give signal to crew in the field. You can disable the beeper
by:
[ConfigurationSYNCBeeper: on/off]
 It records a tone of 1KHz and 2KHz at the beginning of the video and
end of the video when trigger on/off record, as pilot for post-
workflow. Disable the function by:
[ConfigurationSYNCRecording Beeper: on/off]
Menu Operation
Set Beeper
[ConfigurationSYNC
Beeper: on/off]
Menu Operation
Set recording of Beeper
[ConfigurationSYNC
Recording Beeper: on/off]