Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

3.6 TimeCode and SYNC

Timecode is one of key features of cinema camera. The camera shows time

code in the Liveview and Playback state. Timecode is written into recorded

clips. For ProRes, the mov file contains a single timecode track; for RAW,

every single frame contains a specific timecode.

The camera has three types of timecodes:

 Free run: timecode runs all the time, no matter if you recording or

not, and the timecode is embedded into recorded clips;

 Record run: timecode runs only when recording. We suggest to set

timecode to 00: 00: 00: 00 when a new project begins;

 External TC: the camera can use timecode from external device like

Ambient NanoLockit as timecode of camera: using special cable to

connect timecode generator to the TC port (on KineBACK-W), then

set timecode source as external in the menu.

To set the timecode:

[ConfigurationSettingsTimeCode]

Choose the timecode mode or reset the timecode.

3.6.1 TC port and TC cord

The TC port is MOCO 0B 5-pin port as definitions right side. It is compatible

with ARRI Alexa camera TC port for LTC IN and OUT.

For timecode generator based on Ambient timecode system, such as

NanoLockit, also a 0B 5-pin port; check the TC cord on Kinefinity website or

contact sales@kinefinity.com.

In addition, the camera can output timecode to other devices: connect the

TC input port of the device to the TC output port of the camera by a special

TC cord.

NOTE The external mode doesn't support Jam TC input.

Menu Operation

Set the TimeCode

[ConfigurationSettings

TimeCode]

Port Definition

1. GND

2. LTC IN

3,4. NC

5. LTC OUT

3 4