Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

3.5.2 Black Balancing

Every Kine camera has calibrated black balancing before shipping, which is

done under Calibration Mode. After a long period of usage, please do the

balancing again, and factory reset would not change the balancing data.

Please do as following:

1. Enter into Calibration Mode: hold configuration button when press

and release power button, after three seconds, release

[Configuration] button;

2. Calibration: put on lens cover or mount cover to make sure a total

black display, then [Configuration SystemBlack Balancing], it will

take about 5 mins;

3. Factory Reset: [ConfigurationSystem Factory Reset], then reboot

camera.

CAUTION Please reset to factory settings, or camera will stay in calibration

mode after reboot.

NOTE After black balancing, there is no dead pixel in normal ISO, but

there might be a few red/green/blue spot when ISO is

extremely high.

NOTE If there is white dot in some frames, it may be due to the

cosmic rays, not the malfunction of CMOS imaging sensor.

Menu Operation

Black Balancing

[ConfigurationSystem

Black Balancing]