Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

3.5 Firmware Update and Option Upgrade

Updating firmware is easy and quick: download firmware from Kinefinity

website, prepare a USB thumb as FAT32. Besides, you can also downgrade to

the previous firmware version.

3.5.1 Firmware Update

The firmware version is shown at the bottom of Configuration menu, for

example, firmware: KineOS V6.2 (02), means KineOS version is 6.2 with

building number of 6202. Upgrade the firmware as following steps:

1. Download: Download the latest firmware, and copy it to the root

folder of a FAT32 USB disk; insert the USB disk into USB socket of the

camera; there will be an USB label in the UI;

2. Update: do [ConfigurationSystemUpdate Firmware]. Confirm to

upgrade, wait about fifteen minutes till the successful display comes

out;

3. Reboot: Power down, and get USB disk out. Power on, and then the

new firmware takes effective.

If the camera shows the USB information but cannot update the firmware,

please refer to the FAQ.

CAUTION Do NOT take any other operation and never lose power when

update firmware, else it may lead to failure of firmware update,

even camera has to be sent to Kinefinity for repair.

CAUTION Remove any lenses before updating the firmware.

NOTE It is highly recommended that user should restore to factory

settings and do black balancing after the update.

Menu Operation

Update Firmware

[ConfigurationSystem

Update Firmware]