Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

2.4 Monitoring

Please choose a recommended EVF or Field Monitor with Video, 3G-SDI (Not HD-SDI) or HD digital input,

and connect the input port of EVF or monitor to output port of the camera body with a high quality cable.

Suggestions for monitoring:

 KineMON 5″ Full-HD Monitor: with the Kine Video Cord our monitor gets both power supply and

video signal through the same cable. There are many appropriate accessories available to firmly

mount the monitor according different needs.

 SmallHD Monitors 500 series and 700 series: can be connected to the HD Type-A port and two 3G-

SDI ports on the KineBACK-W.

 FSI broadcasting/cine monitor or other monitor with 3G-SDI port as director monitor or DIT monitor.

For the current firmware, HD Type-A port is only for video monitoring, but SDI port also supports audio

signal: output audio during the playback of files.

CAUTION Connect the monitors to the camera by HD video cable or SDI cable (75Ω) before they are turned

on, and please also pay attention to the direction of the D-TAP cord.

NOTE Please choose the LP-E6 Battery Coupler (7.4V) when using the 3

-party monitors.

NOTE The video output is only for monitoring, not recording. The monitoring FPS is different from

CMOS imaging sensor FPS; therefore, the external recorder cannot get the clips with the same

FPS and resolution as CMOS imaging sensor.

Functions of Buttons on KineMON

 PEAK: peaking focus, show the red line peaking as an overlay on a black-and-white image;

 CLIP: marks clip exposure, show the overexposure and underexposure area;

 False: marks false color exposure: overexposure/underexposure areas and the area between;

 Wheel: press the wheel to trigger backlight setting, and rotate the wheel to set the level of backlight.

NOTE Turn off the KineMON to save the power for longer duration.