Operation Manual

MAVO LF Operation Manual（KineOS 6.2）

2.2 Mount

MAVO LF is designed with a native KineMOUNT, which needs a Mounting Adapter II to attach a lens to the

camera. The available adapters include EF Mounting Adapter II, EF Mounting Adapter II with KineEnhancer,

EF Mounting Adapter II with e-ND, PL Mounting Adapter II, PL Mounting Adapter II with e-ND, and also

SONY E Mounting Adapter.

There are only three steps to install a“Lens Mouting Adapter II”to the KineMOUNT, we take EF adapter as

an example. Turn off the camera and then:

1. Release: keep pressing the KineMOUNT Release Button and rotate the locking ring of the

KineMOUNT counter-clockwise  then take off the KineMOUNT cover;

2. Install: there is a positioning slot above the electronic contacts of the KineMOUNT, please align the

arcuate protrusion on the adapter with the locating slot of KineMOUNT when attaching the

mounting adapter to the camera;

3. Lock: rotate the locking ring of KineMOUNT clockwise to fasten the adapter to KineMOUNT firmly.

Power on the camera after mounting the adapter. Press [Configuration] and check the bottom of this menu,

if it presents EF sys 9(or other number), it means you have mounted the adapter successfully.

CAUTION Power off camera when swapping different adapters, else camera or adapters may get burned.

CAUTION As the FFD of KineMOUNT is very short, please don't try to attach any lens directly to

KineMOUNT, or it will cause permanent damage to CMOS imaging sensor and OLPF, except

lenses tailored for KineMOUNT.

NOTE The KineMOUNT only works with Mounting Adapter II.

NOTE When install the EF Mounting Adapter II with KineEnhancer or e-ND, please don't touch the

optical glass. Any damage caused to the glass is irreversible, and the glass has to be replaced.