Installation Guide

ManualsBrandsKINDRED ManualsKitchenDual Mount Granite Composite 33 in. 4-Hole Double Bowl Kitchen Sink in Black

SLOWLY

TIGHTEN

THE CLIP

WITH A

SCREW

DRIVER

SINK

APPLY A BEAD OF

SILICONE SEALANT

AROUND THE RIM

COUNTERTOP

1. With sink in the upside down position, place

a continuous and generous bead of silicone

sealant around the entire perimeter of the

rim. This serves as a watertight seal.

2. Lift sink, turn face up, and lower into the

countertop cutout opening.

3. Line up front rim with the front edge of the

counter.

4. The clip is adjustable to countertop

thickness by flipping the clip over to provide

a tight seal.

5. Underneath the countertop begin tightening

clips with a screwdriver in an even fashion,

alternating sides while tightening, until the

entire rim is sealed.

6. Do not over tighten. It is only necessary to

draw the rim down snugly to the countertop.

7. Wipe excess sealant from perimeter with a

wet cloth.

COUNTERTOP

Step 5

FINISHING

1. Re-connect and tighten hot and cold faucet supply

lines, strainer, drain, and trap assembly.

NOTE: Depending on the location of sink drain

holes it may be necessary to adjust the drain pipe

fittings under the sink to accommodate the new

sink installation.

2. Turn on water supply, check all connections for

leaks. If leak appears, tighten joint slightly. Do not

over tighten.

3. With stopper in place fill sink and check for leaks

under sink and around drain flange.

4. Remove stopper and let water drain while checking

drain connections.

Step 4

INSERTING SINK AND TIGHTENING MOUNTING CLIPS

CARE INSTRUCTIONS

To insure long-lasting beauty the best preventative

maintenance is to ensure that the sink is clean, dry

and exposed to room atmosphere when not in use.

Rinse and towel dry to keep it relatively free of water

spots, especially if you have hard water.

To clean your sink, use the mildest procedure that

will do the job, generally liquid detergent and water.

Rinse and dry.

STAINS. To avoid hard water spots wipe sink dry with

clean soft towel after use.

CAUTION. Steel wool pads leave tiny particles that

may cause rust spots. Rubber mats are acceptable if

removed after each use.

SINK

CLIP