Installation Guide

CUT ALONG DOTTED LINE OF
TEMPLATE PATTERN FOUND
ON SINK PACKAGING.
1.
COUNTERTOP CUT-OUT PATTERN
COUNTERTOP
TRACE COMPLETELY AROUND
EDGE OF CUT-OUT TEMPLATE
USING A 2" HOLE
SAW, DRILL A HOLE
ON THE INSIDE OF
THE LINE THAT WAS
TRACED USING THE
CUT-OUT TEMPLATE.
COUNTERTOP
3.
4.
PREPARING A NEW COUNTERTOP
USING THE CUT-OUT TEMPLATE
PROVIDED
(Included in or on the carton)
1. If template is located on the outside of
the carton cut along dotted line.
2. If template is not located on the outside of
the carton use template provided in the
carton. Measure the cutout line and
compare to all sink dimensions. The
cutout line should be 3/4" smaller than
overall sink dimension.
3. Trace on the countertop completely
around the edge of the template.
4. Drill a pilot hole inside the cutting line.
5. Using a jigsaw, cut along the inside line
to cut the opening in the countertop.
2.
Step 3
INSTALLING ACCESSORIES
Now is the time to attach your faucet and drains to
your new sink. Use plumber’s putty or silicone sealant
under the faucet base and under the top flange of the
drain to provide a leak proof seal.
FAUCET BASE
TOP FLANGE
OF DRAIN
COUNTERTOP
USING A JIGSAW, CUT ALONG OUTLINE
TRACED ON COUNTERTOP.
5.