Installation Guide

CUT ALONG DOTTED LINE OF
TEMPLATE PATTERN FOUND
ON SINK PACKAGING.
1.
COUNTERTOP CUT-OUT PATTERN
COUNTERTOP
TRACE COMPLETELY AROUND
EDGE OF CUT-OUT TEMPLATE
USING A 2" HOLE
SAW, DRILL A HOLE
ON THE INSIDE OF
THE LINE THAT WAS
TRACED USING THE
CUT-OUT TEMPLATE.
COUNTERTOP
COUNTERTOP
USING A JIGSAW, CUT ALONG OUTLINE
TRACED ON COUNTERTOP.
3.
4.
5.
PREPARING A NEW COUNTERTOP
USING THE CUT-OUT TEMPLATE
PROVIDED
(Included in or on the carton)
1. If template is located on the outside of
the carton cut along dotted line.
2. If template is not located on the outside of
the carton use template provided in the
carton. Measure the cutout line and
compare to all sink dimensions. The
cutout line should be 1/2" smaller than
overall sink dimension.
3. Trace on the countertop completely
around the edge of the template.
4. Drill a pilot hole inside the cutting line.
5. Using a jigsaw, cut along the inside line
to cut the opening in the countertop.
2.
INTEGRATED
INSTALLATION
RAIL
FRONT RIM
CLIP
CLIP
CLIP
CLIP
CLIP
CLIP
COUNTERTOP
Step 3
APPLYING MOUNTING CLIPS
In some cases, sink may have clips pre-attached
1. Turn sink upside down onto a clean, soft surface.
2. Six clips are recommended for installation. Two extra
clips are included if required.
3. Slide the clips over the pre-drilled mounting slot
in the sink rim. (See diagram for clip placement)
Make sure clip jaws are facing towards outside
edge of sink.
4. Make sure the clip snaps are fully seated into the
mounting slot.
5. Turn all clip jaws parallel to the sink rim.
Step 4
INSTALLING ACCESSORIES
Now is the time to attach your faucet and drains to
your new stainless steel sink. Use plumber’s putty or
silicone sealant under the faucet base and under the
top flange of the drain to provide a leak proof seal.
FAUCET BASE
TOP FLANGE
OF DRAIN