Manual

25
7. Lightly oil the barrel. NOTE: Run a dry patch
through the barrel before firing to remove oil.
8. Wipe off all dirt on all bearing surfaces on
slide and frame.
9. Clean breech face and all parts (an old
toothbrush or similar nylon brush works well).
10. Follow lubrication directions before re-
assembling.
LUBRICATION
1. Use a High Tech Gun Oil such as Shooters
Choice FP-10 or similar quality oil (grease is
not recommended). If oil contains Teflon be
sure to shake well before using as the Teflon
settles when left overnight.
2. Lubricate the following internal parts of the
pistol:
a. Slide and Frame rails - Oil. Do not over oil!
b. Disconnector on top of frame - Small drop.
c. Barrel Hood - two drops, spread on hood.
d. Slide Stop pin - one drop, spread with
finger.
e. Outside of Barrel - Oil. Do not over oil,
spread with fingertip.