Manual

24
ASSEMBLY
To reassemble, follow steps in reverse order. Align
the barrel linkage block with the slide latch hole
in the frame. The alignment can be seen through
the hole and hole in the block can be aligned by
moving the slide very carefully back and forth
until it drops into place. Align the linkblock hole
first, insert the slide stop shaft and then rotate the
slide stop upward until it aligns with the
disassembly notch. Then push the slide stop
inward until it is properly seated.
CLEANING
Always run the cleaning rods from the chamber end.
1. Disassemble pistol as described in previous
section.
2. Run a wet patch through the bore. Let soak a
few minutes. (Always
read the manufacturers’
directions of the bore cleaner you are using.)
3. Run a dry patch through to remove loose
crud/deposits.
4. Run a wet bore brush through the chamber
end of the barrel a few passes.
5. Run a dry patch to remove the dirt.
6. Repeat steps 4 and 5 a few times until the
patch comes out clean.