Application Guide

1. Before applying the material to your car, make sure that there is no corrosion
(rust) on the metal. If you have such a problem, it's necessary to treat the metal
with an corrosion inhibitor, to apply a primer and to paint the surface. After that
you have to treat the dried surface with a degreaser and only then to apply
sound deadening material to your car.
2. Calculation of proper material quantity is essential for good car soundproofing.
Lack of material can be a severe problem which will delay the body assembling
unless the missing material is received. On the contrary, excessiveness in resources
means wasting money.
3. The ambient, material and vehicle temperature is important for a proper
installation of the mat and shouldn't be below 5°F (15°C). If the temperature is
lower, use a heat gun to heat the material and the surface to 68- 86°F (30-40°C).
But not higher, so as not to damage the car paint. 68- 86°F (30-40°C) - is the best
temperature for the installation as it's perfect for adhesive performance of the
material.
4. Don't forget to use gloves while applying the sound deadening material
to protect your hands as the foil layer of the material has sharp edges.
5. Roller is a must have tool if you want to install your sound deadening correctly
without getting back and correcting the spots that you might have missed.
Having applied the material to the car body, give it a proper run with a roller
(preferably metal) to flatten out that diamond shape dimples on top, that would
mean that material is properly adhered to the surface.
6. It's better to use foil insulation tape to hide sheet joints and material edges.
Useful Tips:

Summary of content (2 pages)