Operator Manual Owner manual

T23_AA_Operator Manual_2014 Revised 08/2014
Maintenance & Adjustments
Danger! All power sources including water pumps must be disconnected and secured
before performing any maintenance or adjustments on your water-Reel. Failure to dis-
connect all power sources before performing maintenance or adjustments may result in
machine damage, personal injury, or death.
Compensator Adjustment:
1. Remove the faceplate of turbine.
2. Remove the spring aached to the turbine compensaon arm.
3. Place the compensaon bar in the shut o posion the boom of the bar will contact the level-
wind frame.
4. Loosen the control wire by loosening the setscrew and the set collar where the control wire con-
nects to the turbine compensaon arm.
5. Adjust the compensaon spoiler to its fully compensated posion it will be pointed directly to-
wards the center of the turbine.
6. Tighten the control wire by ghtening the setscrew and set collar aach the spring and exercise
the compensaon bar to verify the compensaon spoiler funcons properly with no compensa-
on the compensaon spoiler in line with the ow of water and with full compensaon the spoil-
er should be 90 degrees out of line with the ow of water (poinng straight towards center of
turbine).
7. Replace the turbine cover and o-ring.
26