Operator Manual Owner manual

T23_AA_Operator Manual_2014 Revised 08/2014
Start Up & Operaon
Step-by Step Operaon Connued
10. Verify that the coils of tube remaining on the drum are both coiled and packed
ghtly (photo). If they are not use the hand crank and PTO input on the gearbox to
ghten them.
11. Aach supply hose. Verify there are no kinks or twists in the supply hose.
12. Lower the an reverse pawl prior to engaging the drive system.
13. Verify the turbine is o and turn on your pump. If your supply lines have not been used for an extended
period of me, ush them prior to aaching to the Water-Reel.
14. Engage the gear box via the clutch pin.
15. Aer all air is purged from the system and the sprinkler is operang smoothly allow water to go through
the system for several minutes to carry out any trash or debris that may have been in the mainline pipe.
Aer the system is thoroughly ushed, start the drive system by engaging the turbine.
Turbine Drive
Engage turbine and adjust speed control knob
aer system is purged.
Warning! Do not pick up or hold
supply hose as it is being pressurized!
Engaged Position Disengaged Position
Start
Stop
13