Operator Manual Owner manual

T23_AA_Operator Manual_2014 Revised 08/2014
Start Up & Operaon
Step-by Step Operaon Connued
2. Lower the stabilizer legs. Remove the coer pin to the slide bolt holding the stabilizer leg in posion while
holding the handle. Lower each leg into the ground and rmly stomp them into the ground. Replace the
slide bolt & coer pin once lowered.
Warning! Never operate the Water-Reel with only one stabilizer
leg in the ground or without the stabilizer feet rmly inserted in the
ground.
3. AA models are equipped with a standard hand crank jack for making height
adjustments. Lower the jack and level your unit, unhook and pull tractor around
into posion to pull sprinkler cart down the irrigaon lane.
1. Verify that the chassis of your Ag-Rain Water-Reel is level, if not adjust the jack
accordingly. Also verify that both stabilizer legs are securely in the ground.
2. Adjust sprinkler cart to the desired width. See “Specicaon” secon.
3. Lower the sprinkler cart from its transport posion. Set the desired sprinkler arc and conrm that the sprin-
kler is equipped with the proper nozzle. Note: Turbine drive irrigators have a minimum G.P.M. ow
requirement. Do not aempt to operate at ows or pressures dierent from those
listed on the “Performance Guide” decal that is installed on the machine.
4. Li An-Return pawl (Diagram below). Flip the pawl into the up posion.
Important! If the pawl is under pressure, remove the safety guard and the yellow sleeve on the gearbox PTO
sha and remove the key that locks the sha into posion.
An-Return Pawl
Remove Safety Shield Remove Yellow Sleeve Close up of Locking Key in
Sha
Remove Locking Key
11