Operator Manual Owner manual

T23_AA_Operator Manual_2014 Revised 08/2014

Start Up & Operaon

Start-Up & Operaon Procedure

Successful operaon of the Water-Reel irrigaon system depends a great deal on the operator’s understand-

ing of the proper pullout and start-up procedure. Do not aempt to operate this Water-Reel unl you read

and understand the preceding secon tled “Precauons when Handling the Polyethylene Tube”!

Step-by Step Operaon

1. Pull the Water-Reel to the area to be irrigated, parking your Water-Reel and tractor perpendicular to the

irrigaon lane. Pull the turntable lock pin and rotate the spool so that the sprinkler cart is facing down

your irrigaon lane and is approximately 90 degrees away from the chassis. Insert turntable lock pin the

turntable slot plate and replace the coer pin to secure it. Be especially careful to have the spool square-

ly aligned with the sprinkler cart travel path (Diagram Below).

Warning! Do not pull the tube o of the back of the machine. The sprinkler

cart and tube should always be pulled out at approximately a 90 degree angle

to the chassis (diagram below). The stabilizer legs will not hold the load of in-

coming tube if the chassis wheels are not approximately 90 degrees from the

sprinkler cart travel path. See diagram below.

Pull Into Posion

Remove Lock Pin

Rotate Turntable

Replace Lock Pin