Owner Manual

SAFETY INFORMATIONREMOTE CONTROL OPERATION
7
CODE / PAIRING
STOP
SPEED
TURN RIGHT
TURN LEFT
FORWARD
REVERSE
This remote control has a priority function. When the controller is on, the forward/reverse witch of the product
will be ineffective. When the remote control is stopped, the forward/reverse switch of this product can be used.
REMOTE CONTROL BATTERY INSTALLATION
Open the battery compartment at the back if the remote control and add two alkaline batteries (AAALR03). Pay
attention to the polarity of the battery. When the strobe and speed indicators light up, this indicates the battery
pack is correct.
PAIRING : Press and hold the CODE button on the remote control for 2-4 seconds while pressing the paring
button on the bumper car. The car and remote should light up and music should sound. When the low speed light
turns on, this means the pairing is successful. If the pairing fails (low speed light flashes), remove the battery
and repeat the steps above.
BRAKING : Press the STOP button and the bumper car will come to a stop. Pressing STOP again will release
the limit.
FORWARD/BACKWARD: Selecting this option will make the bumper car go forward or backward. Both forward
and reverse options when selected will start out slowly to inhibit sudded impact.
LEFT TURN/RIGHT TURN: Selecting this option will make the bumper car go to the right or left direction.
NOTE: The remote control has energy-saving settings. If the remote control sits idle for more than 10 seconds,
the remote will go into energy saving mode. The lights will turn off. Pressing any button on the remote will “wake”
the remote.
NOTE:After replacing the battery, the remote will need to be paired with the bumper car again.