Instructions / Assembly

1x 5/16x2-1/8”WaferBolt(5/16”atwasher,5/16”t-nut)
1x 1/4x2-1/2”WaferLag(5/16”atwasher)
1 x #8 x 3” Wood Screw
2 x #8 x 2” Wood Screw
Hardware
Wood Parts
1 x Support Diagonal 5/4 x 4 x 24-1/2”
1 x Diagonal 2 x 3 x 42¼”
092
093
D: Loosely attach (092) Support Diagonal to (093) Diagonal with 1 (WB9) 5/16 x 2-1/8” Wafer Bolt (with at
washer and t-nut) then place (093) Diagonal tight and ush to the back of (050) SW Wall Panel. (092) Support
Diagonal to be ush to the bottom of (050) SW Wall Panel. (g. 9.3 and 9.4)
E: Pre-drill pilot hole with a 3/16” drill bit then attach (093) Diagonal to (050) SW Wall Panel with 1 (WL5) 1/4 x
2-1/2” Wafer Lag (with at washer), checking that it remains ush to outside edge. (g. 9.3 and 9.4)
F: Making sure bottom of (092) Support Diagonal is ush to bottom of (050) SW Wall Panel then attach with 2
(S11) #8 x 2” Wood Screws and 1 (S4) #8 x 3” Wood Screw then tighten the bolt. (g. 9.3 and 9.4)
Fig. 9.3
Fig. 9.4
WL5
S11
S4
WB9
Step 9: Attach Diagonals
Part 2
050
5/16”
T-Nut
Flush
S4
WB9
093
5/16” Flat
Washer
050
S11
092
Flush
5/16” Flat
Washer
WL5
34 [e-mail]