Instructions / Assembly

29
Step 13: Back Wall Assembly
Part 1
A: Attach (1894) Back Floor to (1761) Side Joist using 2 (H3) 1/4 x 2-1/2” Hex Bolts (with lock washer, at
washer and t-nut) and 2 (S7) #12 x 2” Pan Screws as shown in g. 13.1.
B: Tap a 1/4” T-Nut in (1761) Side Joist as shown in g. 13.1.
C: On the back side of the assembly, attach (1894) Back Floor to both (1931) Posts, with (1761) Side Joist on
the inside of the assembly, using 2 (H5) 1/4 x 4-1/2” Hex Bolts (with lock washer, at washer and t-nut). (g. 13.2
and 13.3)
D: Attach (2033) MK Mount to (1894) Back Floor with 1 (H13) 1/4 x 3-1/2” Hex Bolt (with lock washer, at washer
and t-nut). (g. 13.2 and 13.3).
Wood Parts
Hardware
Fig. 13.1
Fig. 13.3
Fig. 13.2
Notice hole
positioned down
Back
H3
2 x 1/4 x 2-1/2” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x 1/4 x 4-1/2” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
1 x 1/4 x 3-1/2” Hex Bolt (1/4” lock washer, 1/4” at washer, 1/4” t-nut)
2 x #12 x 2” Pan Screw
1 x Side Joist 2 x 3 x 34-3/4”
1 x Back Floor 5/4 x 4 x 38-1/2”
1 x MK Mount 2 x 3 x 35”
1761
S7
H3
1761
S7
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
H5
H13
2033
1894
1894
H3
1931
2033
1894
1761
1931
H5
H13
H5
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
1/4” Flat
Washer
1/4” Lock
Washer
1-4”
T-Nut
Notice hole towards top
Note: To ensure there are
no assembly issues with the
Monkey Ladder assembly and
subsequent assembly steps
the recommended gap opening
between (2033) MK Mount and
(1931) Post is 17-1/8” maximum
and must be maintained. (g.
13.3)
17-1/8”
max