Installation Instructions

24
PROG
REPEAT
WAKE
LIGHT
2
10 11
CDG Mode
Pairing Your Device Via Bluetooth
This unit has an AUX-IN jack, through this jack other audio
sources (MP3 players, etc) can be connected to this unit and be
amplified.
1. Turn on the unit and set the Mode Button to AUX. “AU” will
glow solid on the LED screen.
2. Connect one end of a 3.5mm audio cable (not included) into
the AUX-IN jack and the other end to the headphone jack of
your audio device.
3. Press PLAY on your audio device to start playback.
Control/navigate tracks from your audio device, too.
AUX Mode
For questions or comments regarding this or other eKids products, please
call our toll-free number: 1-888-TOP-TOYS
Please also visit our website: www.ekids.com
Questions or Comments
673 IB_Back side Size: 357 x 201 mm Color: Black
27
1
Make sure your Bluetooth device is fully charged. Turn on your
Bluetooth device and turn on Bluetooth mode (check in
Options or Settings).
• Turn on the unit and set the Mode Button (6) to BT mode.
Press the Bluetooth Pairing Button (17). A tone will sound
and the LED screen will flash ‘bt’ as the speaker enters
pairing mode.
• “Karaoke 673” should appear on your device’s screen. If “Not
Connected” or similar message appears, select
“Karaoke 673” to connect. If your device asks for a passcode,
enter ‘1234’.
• Once paired, a confirmation tone will sound and ‘bt” will glow
solid on the LED screen. Put your Bluetooth device in Play
mode to stream audio to the speaker. Use your Bluetooth
device OR the Play/Pause, Previous Track, and Next Track
buttons on the unit to control audio functions.
Connect the included microphone to the input jack (25) on the
unit. Turn on the unit and choose Bluetooth, AUX, or CDG
modes using the Mode Button (6).
1. Slide the switch on the Microphone to ON. Now you can sing
along to your favorite music in either CD, Bluetooth, or AUX
modes, and hear your voice through the speaker!
2. When not in use, slide the Microphone switch to OFF. Unlock
the removable slots on the side of the unit to store your
microphone, as shown in the image on the right.
Using the Microphone
Vocal Effects
Use the Auto Voice Control (14) or the Echo Effect (5) to add
vocal effects while you sing! Make sure your microphone is
connected to the unit and the microphone switch is turned ON.
Auto Voice Control Dial (For Multiplex CDG discs only):
When playing a Multiplex recording, spin the dial to replace the
lead singer’s voice with your own!
Echo Effect Rotary Dial:
Spin the dial as you sing to add an echo effect to your voice!
26
Back of Unit
Repeat/Program Buttons
To repeat a track on your CD, press the Repeat Button (16) on
the unit. The “Repeat” LED Indicator will blink. Press again, the
“repeat" LED indicator will glow solid, and the unit will repeat all
tracks. Press again to cancel the ‘repeat all’ program.
You can also program up to 20 tracks of the CD in a desired
order. With CD playback stopped, press the Program Button
(15) once.The "PROG" LED indicator blinks, and the LED
display shows the program number.
Press the Previous Track (8) and Next Track (12) Buttons to
select a track number. When the desired track number is
displayed, press the Program Button to confirm entry.
Repeat these steps until all desired tracks are entered. To begin
programmed playback, press the Play/Pause Button (11). To
cancel programmed playback, press the STOP button twice.
This unit plays CD, CDR, and CDG formats. To play a CD or
CDR, turn on the unit and set the Mode Selector (6) to CDG.
• Open the disc compartment on the top of the unit and insert
the disc face up. Close the compartment door.
• Use the controls to play/pause (11), stop (10).or navigate
tracks (8,12).
The RCA cable should be installed by an adult. To play a CDG
disc on your television:
• Connect the included RCA cable (white and red connectors)
to the RCA audio output jacks located at rear of the unit (27).
• Connect the other end of the audio cable to the RCA audio
input jack of a TV set.
• Connect the RCA video cable (yellow connector) to the RCA
video output jack located at rear of the unit (27).
• Connect the other end of the video cable to the RCA video
input jack of a TV set, and make sure your television is set to
the corresponding input.
• Turn on the unit and set the Mode Selector (6) to CDG.
• Insert a CDG disc into the unit and press the Play/Pause
Button (11). Now you can follow the lyrics on the screen and
sing along through the microphone!
• Use the Previous Track (8) and Next Track (12) buttons to
navigate tracks on the CDG.
28
2. Light Button
3. LED Power Indicator
1. Wake Button
4. Power ON/OFF
5. Echo Effect Rotary
6. Mode Button: CDG/BT/AUX
7. Mic Volume Rotary
8. Previous Track Button
9. LED Display
10. Stop Button
11. Play/Pause Button
12.
13.
14.
15.
16.
17. Bluetooth Pairing Button
18. Random Play
19. CD Compartment
20. Mode Indicator
Next Track Button
Master Volume Rotary
Auto Voice Control
Program Button
Repeat Button
21. Microphone
22. Microphone ON/OFF
23. Light Show LEDs
24. Speaker
25. Microphone Jacks
3
5
7
12
13
14
15
16
17
18
19
21
22
23
26. AUX-IN Jack
27. RCA Audio/Video Jack
28. DC Power Jack
29. Phone Stand - Not
Recommended for Use
with Tablets
25
ECHO
A.V.C
MAX
MIN
MAX
MIN
MAX
MIN
MAX
MIN
4
CDG
PROG PLAY/PAUSE
REPEAT
9
20
23
6
8
29
Using The Light Button:
By default, the unit will
display a repeating light
pattern when no music is
playing. When music plays,
the unit will activate ‘beat
detection’, and lights will
pulse along to music.
• Press to play repeating
Light pattern
• Press again to turns light
off
• Press again to return to
default setting
If the unit is experiencing a fuzzy or distorted sound, check the batteries.
They are most likely weak and need to be replaced with 8 brand new “C”
batteries.
Troubleshooting