Use and Care Manual

Whenever the alarm is operating, the green Power LED is illuminated
and the digital display will display “0” to indicate the unit is monitoring
for CO. If the alarm senses dangerous levels of CO, the red Alarm LED
will flash, the amber LED will be lit, the digital display will indicate the
CO concentration in parts per million (PPM), and the alarm will emit an
audible alarm pattern.
This alarm will display a “0” if CO concentrations between 0 and 30
PPM have been detected within the last 30 seconds.
When the unit is first powered up, the digital display will show three
“eights” – indicating the alarm is in the start-up mode. The three
“eights” will remain for approximately 20 seconds. After 20 seconds,
the alarm should display “0” and begin monitoring the air for CO and
will continue to do so as long as it receives power.
6. Model KN-COPF-i Operating Characteristics
The following table illustrates the possible digital displays, describes the
audible alarm patterns, and the recommended actions to take.
Operating and Alarm Characteristics
Brief “888” along
with any number
between 100 and 300.
Red LED flashes with beeps.
Green and amber LED’s on.
4 quick beeps,
5 seconds
silence,
repeated once
Self checking when
AC powered (Test
button was pressed
or unit was first
powered)
None – CO has not
been detected.
Numbers shown for
test purposes only
Steady “0” and green
LED constantly on.
None Normal AC
operation (sensing
no CO) and with a
good battery
None
A steady display of
CO concentration
from 30-999. Red
LED flashes with beeps. Amber
LED shows initiating alarm.
4 quick beeps,
5 seconds
silence,
repeating
Alarm condition.
Dangerous
concentrations of
CO detected at
location of alarm.
Refer to “What to do
When the Alarm
Sounds” (inside front
cover)
“Lb” flashes
alternately with
any number.
Red LED flashes
every 60 seconds.
One quick
beep every
60 seconds
Battery voltage is
low.
Ensure AC power is
present and allow
battery to charge for
several hours
Steady “CO”
Red LED flashes with
beeps. Amber LED
NOT illuminated
4 quick beeps,
5 seconds
silence,
repeating
Interconnected CO
alarm warning of a
CO condition at
different location.
Refer to “What to do
When the Alarm
Sounds” (inside front
cover)
“FirE”
Red LED flashes
with beeps
3 long beeps,
1 second
silence,
repeating
Interconnected
smoke alarm
warning of a
smoke/fire condition
Evacuate by your
escape plan
LED Display Shows Alarm Sound Unit Status Recommendation
2527-7201-00(820-1387A):_ 2008.5.12 9:35 AM Page 16