Specification
1394 South Third Street, Mebane NC 27302
1-800-880-6788 • www.kiddeus.com
AC Powered, Plug-In
Carbon Monoxide Alarm
Part Number 900-0107
Model KN-COPB-DP-H
Architectural and Engineering
Specifications
The carbon monoxide alarm shall be Kidde Unit Number
KN-COB-DP-H (part number 900-0107) or approved equal. It
shall be powered by a 120VAC, 60 Hz source. The temperature
operating range shall be between 40˚F and 100˚F (4˚C and 38˚C)
and the humidity operating range shall be 5%-95% relative
humidity.
The CO sensor shall be of a fuel cell design and shall meet
the sensitivity requirements of Underwriters Laboratories
UL2034 Single and Multiple Station Carbon Monoxide Alarms.
The alarm shall include an integral plug that can be installed
in any electrical outlet following the UL/NFPA/Manufacturer’s
recommended guidelines. The unit shall have a green LED that
will illuminate continuously and indicate that the CO alarm is
receiving power and the alarm circuit is functioning.
The alarm shall include a test/reset button. If pressed and
released during normal operation, it shall electronically simulate
the presence of CO and cause the unit to go into alarm. This
sequence tests the unit’s electronics to ensure proper operation.
If pressed during alarm mode, the unit will be silenced and will
begin monitoring CO levels again.
In accordance with UL 2034, the CO sensor will not alarm
to levels of CO below 30 ppm and will alarm in the following
time range when exposed to the corresponding levels of CO.
70 ppm CO concentration 60 – 240 minutes
150 ppm CO concentration 10 – 50 minutes
400 ppm CO concentration 4 – 15 minutes
The alarm shall include a piezoelectric horn that is rated at
85 decibels at 10 feet. When the unit detects carbon monox-
ide, the alarm pattern will be four (4) short beeps – followed by
five (5) seconds of silence – followed by four (4) short beeps.
The unit shall be listed to UL 2034. It shall also include a
5-year manufacturer’s limited warranty.
Technical Specifications
Part Number: 900-0107
Model: KN-COB-DP-H
Power Source: 120VAC, 60 Hz 60mA max.
Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 5%-95% relative humidity (RH)
Size: 5”W x 3.875”H x 1.6875”D
Weight: .5lb
Interconnects: No
LED: Green, Normal; Red, Alarm
Warranty: 5 year limited
*Based on accuracy claims of major manufacturers
Ordering Information
UPC: 7-84908-01070-4
Part Dimensions Case/ Layers/ Skid
Number I 2 of 5 Pack Quantity (w x d x h inches) Weight Skid Skid Weight
900-0107** N/A Individual 7.5 x 2.5 x 11.25 .5lb N/A N/A N/A
900-0107-02 107 84908 01070 1 PDQ (2 units) 8 x 6.25 x 11.25 1.5lbs 105 3 374lbs
900-0107-16 207 84908 01070 8 Cut Case (12 units) 14.75 x 17.5 x 12 8lbs 18 3 360lbs
900-0107-37 307 84908 01070 5 Power Tower (36 units) 20 x 24 x 41 (incl. pallet) 40lbs 3 3 60lb
*Based on accuracy claims of major manufacturers
20
60
4
1
UNIT MASTER PACK CUT CASE POWER TOWER
UNIT MASTER PACK CUT CASE POWER TOWER
1
UNIT MASTER PACK
12
0916
1
UNIT MASTER PACK
6
900-0120
1
UNIT MASTER PACK
20
0913
UNIT CUT CASE POWER TOWER
440375
9CO-5
900-0107
900-0076
PDQ
1
1
3
PDQ
2
PDQ
3
4
12
3
20
60
UNIT CUT CASE POWER TOWER
1
20
CUT CASE
2
60
PDQ
2
UNIT CUT CASE POWER TOWER
1
12
36
5"
1.6875"
3.875"
Distributed by: