Owner's Manual

battery when this condition occurs.
The low battery chirp will occur approximately 20 seconds after
the red LED flash.
USE ONLY THE FOLLOWING 9 VOLT BATTERIES FOR SMOKE
ALARM REPLACEMENT.
Carbon Zinc Type: EVEREADY 1222; GOLD PEAK 1604S
Alkaline Type: ENERGIZER 522; DURACELL MN1604,
MX1604, GOLD PEAK 1604A ;
PANASONIC 6AM6, 6AM-6, 6AM-6PI,
6AM6X, 6LR61(GA)
Lithium Type: ULTRALIFE U9VL-J
These batteries can be purchased at your local retailer.
NOTE: WEEKLY TESTING IS REQUIRED.
WARNING!! USE ONLY THE BATTERIES SPECIFIED. USE OF
DIFFERENT BATTERIES MAY HAVE A DETRIMENTAL EFFECT
ON THE SMOKE ALARM.
CLEANING YOUR ALARM
YOUR ALARM SHOULD BE CLEANED AT LEAST ONCE A YEAR
To clean your alarm, remove it from the mounting bracket as out-
lined in the beginning of this section (If tamper resist feature has
been used, refer to "REMOVING ALARM WITH TAMPER RESIST
FEATURE ACTIVE" in Section 3 for removal instructions).
You can clean the interior of your alarm (sensing chamber) by
using compressed air or a vacuum cleaner hose and blowing or
vacuuming through the openings around the perimeter of the
alarm. The outside of the alarm can be wiped with a damp cloth.
After cleaning, reinstall your alarm and test your alarm by using
the test button. If cleaning does not restore the alarm to normal
operation the alarm should be replaced.
Do not paint your alarm. Paint will seal the vents and interfere
with the alarms ability to detect smoke and produce sound. Never
attempt to dismantle the alarm or clean the inside, as this will void
the warranty.
7. LIMITATIONS OF SMOKE ALARMS
WARNING: PLEASE READ CAREFULLY AND THOROUGHLY