Owner's Manual

ManualsBrandsKidde ManualsAlarmsKidde Code One G,AD,1012,1018 English 110570H

Troubleshooting

REPLACE OR RETURN THE ALARM IF THE PUSH-TO-TEST

FUNCTION DOES NOT OPERATE PROPERLY AFTER FOLLOW-

ING THE PROCEDURES OUTLINED ABOVE (see REPAIR on

page 7).

Warranty

Code One Safety warrants to the original consumer purchaser

each new smoke alarm to be free from defects in material

and workmanship under normal use and service for a period

of three (3) years from date of purchase. Code One Safety

agrees to repair or replace, at its option, any defective

smoke alarm, provided that it is returned with postage pre-

paid and with proof of purchase date to Code One Safety.

This warranty does not cover damage resulting from accident,

misuse or abuse or lack of reasonable care of the product.

This warranty is in lieu of all other express warranties, obliga-

tions or liabilities.

THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS

FOR A PARTICULAR PURPOSE ARE LIMITED TO A PERIOD OF

three (3) YEARS FROM PURCHASE DATE. Some states do

not allow limitations on how long an implied warranty lasts,

so the above limitations may not apply to you. IN NO CASE

SHALL CODE ONE SAFETY BE LIABLE FOR ANY INCIDENTAL

OR CONSEQUENTIAL DAMAGES FOR BREACH OF THIS OR

ANY OTHER WARRANTY, EXPRESS OR IMPLIED, WHATSOEVER,

EVEN IF THE LOSS OR DAMAGE IS CAUSED BY ITS NEGLIGENCE

OR FAULT. Some states do not allow the exclusion or limitation

of incidental or consequential damages, so the above limitation

or exclusion may not apply to you. This warranty gives you

specific legal rights, and you may also have other legal rights

which vary from state to state.

DANGER ALWAYS TURN OFF POWER AT MAIN FUSE BOX OR

CIRCUIT BREAKER BEFORE TAKING

TROUBLESHOOTING ACTION.

WARNING DO NOT DISCONNECT BATTERY OR AC POWER TO

QUIET AN UNWANTED ALARM. THIS WILL REMOVE

YOUR PROTECTION. FAN THE AIR OR OPEN A

WINDOW TO REMOVE SMOKE OR DUST.

PROBLEM SOLUTION

Smoke alarm does not sound

when tested.

1. Check that AC power is

turned on.

2. Turn off power. Remove

smoke alarm from mounting

plate and:

a. check that connector plug

is securely attached.

b. check that battery is prop-

erly attached to connector

(Model AD only).

3. Clean smoke alarm.

Smoke alarm beeps about

once a minute (Model AD only)

Turn off power and replace

battery. See “Battery

Replacement” in the MAINTE-

NANCE AND CLEANING section.

Smoke alarm sounds unwant-

ed alarms when residents are

cooking, taking showers, etc.

1. Clean smoke alarm.

2. Hire an electrician to move

smoke alarm to a new

location. See SMOKE ALARM

PLACEMENT.

Interconnected smoke alarms

do not sound when system is

tested.

Press and hold test button for

at least three seconds after the

first unit sounds.

Code One Safety

28C Leigh Fisher Blvd.

El Paso, TX 79906 USA

110-570H English 11/8/06 11:05 AM Page 8