Owner's Manual

2. To open battery door, insert screwdriver into slot and depress

while sliding door open.

3. Remove drained battery from compartment and discard.

4. Insert a fresh 9-volt battery.

5. Slide battery door closed.

6. Turn on power and test smoke alarm using FALSE

ALARM/TEST button.

7. For item 755 only, confirm that red LED is not flashing. If not,

repeat testing procedure until it does.

Use only the following batteries as replacements: Model 755

Eveready 522, 216, 1222 or Duracell MN 1604.

WARNING: Using inferior batteries or the incorrect type may

cause the alarm to malfunction.

NOTE: The 755RL rechargeable lithium batteries are permanent-

ly mounted and sealed in the tamper-proof housing. These cells

are designed to last the useful life of the Smoke Alarm of 10

years. The 755 has a front access battery door which allows a

home owner to safely change the battery.

OPERATION AND TESTING

• The Clipsal Lifesaver

755 Series Smoke Alarms are opera-

tional once all of the connections are correctly made, the 9V

battery installed (model 755) and mains power restored.

• Test the alarm by pushing the FALSE ALARM/TEST button

for 5 seconds. The alarm should sound simultaneously.

• This test should be done at least once a week to ensure that

the alarm is operating correctly.

• The 755 has a ramp-up test feature that emits two reduced-

volume beeps before reaching the full 85dB level during

testing.

• If interconnected alarms are installed, pushing the FALSE

ALARM/TEST button on one unit should cause all

interconnected units to sound.

• If the alarm does not sound, check the wiring, 9V battery,

fuses or circuit breaker and make sure that the alarm is con-

nected to a 240V a.c. supply which cannot be inadvertently

turned off.

Insert

Screwdriver here