Use and Care Manual

• Permanent independent smoke and carbon monoxide

sensors.

• Smoke alarm takes precedence when both smoke

and carbon monoxide are present.

• Alarm/Voice message warning system that alerts you of

the following conditions in the manner described

below, thus eliminating any confusion over which

alarm is sounding:

– FIRE: The alarm/voice pattern is three long alarm

beeps followed by the verbal warning message

“FIRE! FIRE!”. This pattern is repeated until the

smoke is eliminated. The red LED light will flash

while in alarm/voice mode.

– CARBON MONOXIDE: The alarm/voice pattern is

four short alarm beeps followed by the verbal

warning message “WARNING! CARBON

MONOXIDE!”. After four minutes the alarm/voice

pattern will sound once every minute until the

unit is reset, or the CO eliminated. The red LED

light will flash while in alarm/voice mode.

– LOW BATTERY: When the batteries are low and

need replacing the red LED light will flash and the

unit will “chirp” one time, followed by the warning

message “LOW BATTERY”. This cycle will occur once

every minute for the first hour. After the first hour

the red LED light will continue to flash every minute

accompanied by the “chirp” only sound. The voice

message “LOW BATTERY” will sound once every

fifteen minutes during the “chirp” only cycle.

This will continue for at least seven days.

• One “chirp” every 30 seconds is an indication that

the alarm is malfunctioning. If this occurs call the

Consumer Hotline at 1-800-880-6788.

Features

2505-7201-04 2007.1.26 5:12 PM Page 6