Instructions

3
A
T
T
A
2.LOCATIONS TO AVOID
• In the garage. Products of combustion are present when you start your
m
otor vehicle.
•
Less than 50 cm (20") from a side wall.
•
More than 0.9 m (3') from the peak of an "A" frame type ceiling (measured
horizontally).
• Do not install where the ventilation openings in the unit could be impeded by items
such as newspapers, table-cloths, curtains, etc.
• Less than 102 mm (4") from the peak of an "A" frame type or sloped ceiling
(measured vertically).
• In an area where the temperature may fall below 0ºC (32ºF) or rise above 40ºC
(104ºF), such as garages and unfinished attics.
• In dusty areas. Dust particles may cause nuisance alarm or failure to alarm.
• In very humid areas, above 93% RH, non-condensing. Moisture or steam can cause
nuisance alarms.
• In insect-infested areas.
• Smoke alarms should not be installed within 3 ft (.9m) of the following: the door to a
kitchen, the door to a bathroom containing a tub or shower, forced air supply ducts
used for heating or cooling, ceiling or whole house ventilating fans, or other high air
flow areas.
• Kitchens. Normal cooking may cause nuisance alarms.
• Near fluorescent lights, including CFL lamps. Electronic “noise” may cause nuisance
alarms.
• Smoke alarms are not to be used with detector guards unless the combination
(alarm and guard) has been evaluated and found suitable for that purpose.
• Storage and Transport Conditions: -20° C to +60° C, 5-95%RH (non-condensing)
WARNING: To reduce the risk of fire or electric shock, do not expose this
apparatus to rain or moisture. (or equivalent).
3.INSTALLATION INSTRUCTIONS
Apparatus should be installed by a competent individual.
CAUTION: THIS UNIT IS SEALED (INCLUDING THE BATTERY). THE COVER IS
NOT REMOVABLE!
!
!
FIGURE 4
When mounting
in a hallway, the
“A” line should
be parallel with
the hallway.
1. To ensure aesthetic alignment of
the alarm with the hallway or wall,
the “A” line on the mounting
bracket should be parallel with the
hallway when ceiling mounting or
horizontal when wall mounting.
FIGURE 6
Remove
Install
FIGURE 5
When wall
mounting, the
“A” line should
be horizontal.
0308-7201-09(21008570C)_En_KM738872_V1.qxd:_ 2021.6.21 3:19 PM Page 4