Use and Care Manual

If the smoke is not too dense, after up to ten minutes the alarm will return to

normal operation.

NOTE: Dense smoke will override the SMART HUSH

feature and

sound a continuous alarm.

CAUTION: Before using the alarm SMART HUSH

feature, identify

the source of the smoke and be certain safe conditions exist.

8. BATTERY

NOTE: This alarm is powered by a sealed lithium battery system. No battery

installation or replacement is necessary for the life of the alarm.

IMPORTANT: Constant exposure to high or low humidity may reduce battery life.

WARNING! DO NOT ATTEMPT TO OPEN THE ALARM

FOR ANY REASON!

Do not try to repair the smoke alarm yourself. No serviceable parts included.

Low battery: This alarm is equipped with a low battery monitor circuit which

will cause the alarm to produce a single 'chirp' approximately every 60 seconds,

followed by the voice message "Low Battery", and the red LED to blink every

30 seconds. For the first 5 minutes of low battery, the voice message will occur

once every 60 seconds. After 5 minutes, the voice message will occur once

every 15 minutes. After 60 minutes of low battery, the voice message will no

longer occur but the alarm will continue to chirp every 60 seconds and blink

every 30 seconds for a minimum of seven (7) days.

THE UNIT MUST BE REPLACED WITHIN 7 DAYS OF THE FIRST OCCUR-

RENCE OF THE “LOW BATTERY WARNING” TO PROVIDE CONTINU-

OUS ALARM PROTECTION. THE UNIT MUST BE DISCHARGED (SEE

“PERMANENTLY DISABLE ALARM / DISCHARGE BATTERY” SECTION)

WHEN ALARM IS IN “LOW BATTERY” CONDITION.