Use and Care Manual

ManualsBrandsKidde ManualsElectricalQuick Connect Wiring Adapter for Hardwired Smoke and Combination Detectors

Smoke and Smoke + Carbon Monoxide Alarm Adapter

Model 20-9003

Quick Connect wiring adapter for connecting to existing

Kidde/Firex wire harnesses.

• Designed for use with Kidde hardwired alarms.

• Not compatible with other manufacturer’s products.

Description

This adapter can be used to quickly connect Kidde alarms with the existing

wiring harness without having to re-wire or replace the wiring harness:

i12020, i12020A, i12040, i12040A, i12060, i12060A, i12080, i12080A,

i4618A, i4618AC, KN-SMFM-I, RF-SM-ACDC, PE120, P12040, Pi2000, Pi2010,

KN-COSM-I, KN-COSM-IB, KN-COSM-IBA, KN-COPE-I, KN-COB-IC, SL177i,

SLED177i, HD135F, SM120X, CO120X, i12010S, i12010SCO, P4010ACSCO,

P4010ACSCO-W, P4010LACS-W, P4010ACS, P4010ACS-W, P4010ACLEDS,

P4010ACLEDS-2, P4010ACLEDSCO, P4010ACLEDSCO-2, 3050-VAS10-A,

3050-VASC10-A, P4010ACS-WF, P4010ACSAQ-WF, P4010ACSCO-WF,

P4010ACSCOAQ-WF. See Kidde.com for complete list.

10-YEAR LIMITED WARRANTY

Images are representative only.

Actual product may vary slightly.

Ordering Information

Ordering

Number UPC GTIN Pack Conﬁg Pack Qty

Case Dimensions

(w x d x h inches) Case Weight (lbs) Cartons/Pallet

21032239 047871322398 10047871322395 Box Tray/Lid (6 Units) 5.14 x 10.81 x 3.09 3.1 2016

1016 Corporate Park Drive, Mebane, NC 27302

1-800-880-6788 www.Kidde.com

A Carrier Company

All trademarks and service marks referred herein

are property of their respective owners.

FIGURE 1:

Compatible existing

Kidde harnesses

FIGURE 2:

Adapter connecting

to the old harness

WARNING: Turn o AC power before attempting to connect wire harnesses or

adapters. This smoke alarm adapter allows the installation of new Kidde alarms to

existing “legacy” Kidde wiring harnesses. When using this adapter, the power harness

supplied with your new Kidde alarm is not used. Connect the 20-9003 adapter to the

legacy (existing) Kidde wiring harness. To install the adapter, push the large end of the

adapter into the existing wired Kidde harness and conﬁrm it snaps into position. Give

a small tug to make sure the adapter is snapped into place. Then insert the opposite

end of the adapter into the back of the new unit. After installation, turn on AC power

and be sure that the AC power indicator is operating and test all your alarms following

the instructions supplied by the alarm manufacturer for your speciﬁc alarm model. If the

alarms are interconnected push the test button on each alarm and verify that all the

interconnected alarms sound when any alarm is activated. The interconnect system

should not exceed the NFPA interconnect limit of 12 smoke alarms. SEE USER GUIDE

FOR COMPLETE INSTRUCTIONS.

Kidde

Alarm Adapter

Kidde Existing

Wire Harness

New Kidde Alarm