Use and Care Manual

15
CO ALARM SENSOR RESPONSE TIMES
At 70 PPM, the unit must alarm within 60-240 minutes.
At 150 PPM, the unit must alarm within 10-50 minutes.
At 400 PPM, the unit must alarm within 4-15 minutes.
Indoor Air Quality Parameters
NOTE: The indoor air quality monitor may not react to some particles and its readings may be different
from that of other air quality measuring products and instruments.
Testing
Test your alarm weekly by pressing and releasing the Test/Hush button quickly. A quick beep will
confirm the button has been pushed followed by the test sequence. See Other Alarm Visual and Audible
Indicators table. The alarm will sound if the electronic circuitry, horn, and battery are working. If the
alarm does not sound, or gives erratic or low volume sound, the unit must be replaced. See Permanently
Disable Alarm / Discharge Battery section to determine how to prepare the unit for shipment or disposal.
WARNING: DUE TO THE LOUDNESS OF THE ALARM, ALWAYS STAND ABOUT 2.5 FEET
AWAY FROM THE UNIT OR USE EAR PROTECTION WHEN TESTING.
WARNING: DO NOT USE AN OPEN FLAME TO TEST YOUR ALARM, YOU COULD
DAMAGE THE ALARM OR IGNITE COMBUSTIBLE MATERIALS AND START A STRUCTURE FIRE.
Chirping
This unit samples the ambient light conditions of the alarm’s location and, if possible, determines a Night /
Day cycle. A valid Night / Day cycle will delay low battery, fault, and end of unit life chirps during the night
until the next Day cycle begins. When chirping begins during the next Day cycle, you can temporarily
silence Low Battery or End of Unit Life chirps Life by pressing the Test/Hush button. If a valid Night / Day
cycle has not been established because the unit is located in either a constantly dark or lighted location,
the chirps mentioned above will not be delayed at night. Moving the unit to a different location might
allow the unit to determine a valid Night / Day cycle.
WARNING: REPLACE UNIT AS SOON AS POSSIBLE WHEN IN END OF UNIT LIFE OR LOW
BATTERY MODE.
Air Quality
Visual
indications
Relative Humidity (%)
Approx. VOC conc.
(ug/m^3)
Temperature (F)
Good 30-50 <1,000 <=77 & >=64
Moderate 25-30 or 50-60 <3,000 >77 & <=79 or <64 & <=62
Bad 20-25 or 60-70 <10,000 >79 & <=92 or <62 & <=48
Very Bad <20 or >70 >10,000 >92 or <48
CO 50 PPM
CO 50 PPM
70 F 80% H
PRIOR CO 234 PPM
LOW BATTERY
IAQ GOOD
IAQ xxx CO 0PPM
IAQ MODERATE IAQ BAD IAQ VERY BAD
CO 100 ppm
PROGRAMMING.. WIFI CONNECTING..
E R R O R
REPLACE UNIT
CO TEST
?
PROGRAMMING..
CO 50 PPM
CO 50 PPM
70 F 80% H
PRIOR CO 234 PPM
LOW BATTERY
IAQ GOOD
IAQ xxx CO 0PPM
IAQ MODERATE
IAQ BAD IAQ VERY BAD
CO 100 ppm
PROGRAMMING.. WIFI CONNECTING..
E R R O R
REPLACE UNIT
CO TEST
?
PROGRAMMING..
CO 50 PPM
CO 50 PPM
70 F 80% H
PRIOR CO 234 PPM
LOW BATTERY
IAQ GOOD
IAQ xxx CO 0PPM
IAQ MODERATE
IAQ BAD
IAQ VERY BAD
CO 100 ppm
PROGRAMMING.. WIFI CONNECTING..
E R R O R
REPLACE UNIT
CO TEST
?
PROGRAMMING..
CO 50 PPM
CO 50 PPM
70 F 80% H
PRIOR CO 234 PPM
LOW BATTERY
IAQ GOOD
IAQ xxx CO 0PPM
IAQ MODERATE IAQ BAD
IAQ VERY BAD
CO 100 ppm
PROGRAMMING.. WIFI CONNECTING..
E R R O R
REPLACE UNIT
CO TEST
?
PROGRAMMING..