Use and Care Manual

9.4 Amazon Alexa and Google Assistant

Your WiFi alarm is compatible with Amazon Alexa and Google Assistant. Follow instructions in the

Kidde app help section to link your WiFi alarm to Amazon Alexa and/or Google Assistant.*

* AMAZON and ALEXA are trademarks of Amazon Technologies, Inc. or its affiliates.

Google and Google Assistant are trademarks of Google LLC.

CO ALARM SENSOR RESPONSE TIMES

At 70 PPM, the unit must alarm within 60-240 minutes.

At 150 PPM, the unit must alarm within 10-50 minutes.

At 400 PPM, the unit must alarm within 4-15 minutes.

10. Operation and Testing

Operation

The alarm is operating once it is activated and

testing is complete. When products of com-

bustion (CO) are sensed, the unit sounds a loud alarm. The digital display will also show the level of CO

detected in PPM. (See Section 1 for alarm signal descriptions). In high levels of CO, the unit will go into

alarm in a shorter period of time than at low levels of CO.

Indoor Air Quality

This device is designed to monitor levels of temperature, relative humidity and total volatile organic

compounds (TVOC) – chemicals in the air that can impact your health. Visit www.epa.org for more

information on VOCs. Relative Humidity % (RH) refers to the percentage of water vapor in the air at a

given temperature. Ideal RH for living conditions is usually recommended at 30% - 60%. The parame-

ters listed below are based on a typical average, climate controlled residence. When conditions in the

residence move outside of the limits shown in the table, an alert is sent to your mobile device. You can

also check the status of your indoor air quality using the Kidde app, after your alarm is registered with

the app.