Use and Care Manual

NOTE : At any time during Wi-Fi enrollment, if you have a problem, you can push and hold the button

on any problem unit until you hear two (2) beeps (approx 8 sec), and then release the button. The unit

will reset the unit’s wireless settings (described in Section 9.3). Once wireless settings are reset, the unit

will search for an existing Wi-Fi network.

If you are installing for Wi-Fi functionality, and have not yet downloaded the Kidde App, do not

plug your Wi-Fi unit into the wall outlet yet. See Section 8 for instructions on downloading the Kidde App.

NOTE: This model supports bilingual American English AND Canadian French languages for display messages. The

default is American English. The display language can be toggled by pressing the “Test” button twice in succession.

Note: All documentation is only available in American English.

9.1 Setting Up Wi-Fi Enrollment

A. Choose plug orientation, plug-in alarm.

• Remove the switch cover.

• Choose a standard 120V non-switched outlet to plug the alarm into.

• If outlet is mounted sideways (horizontally), rotate the plug and plug

the alarm in.

• The LCD will blink the question mark Wi-Fi icon with message “PROGRAMMING”.

CAUTION: Do not rotate the alarm while it is plugged into an outlet, as

damage to plug may result.

B. Open the Kidde App and follow instructions on the App to finish Wi-Fi enrollment.

NOTE: If no further steps are taken within 15 minutes of initial power up, the Wi-Fi function

will turn off. The unit will then perform as a standard CO alarm. See Section 9.3 for reactivat-

ing Wi-Fi features.

C. After the Wi-Fi enrollment is completed, the “PROGRAMMING” message will turn off, and the unit

will enter Normal (standby) mode.

D. Repeat steps A through C with each alarm to be enrolled with Wi-Fi.

90º ROTATING DIRECT

PLUG