Specification

Intelligent Alarm
Battery Operated Combination
Carbon Monoxide, Fire & Smoke Alarm
Part # 900-0216A
Model KN-COSMXTR-BA
Architectural and Engineering
Specifications
The combination smoke and carbon monoxide alarm shall be Kidde
Model Number KN-COSMXTR-BA (part number 900-0216A) or
approved equal. It shall be powered by 2 AA batteries. The unit
shall incorporate an ionization smoke sensor with nominal sensitivity
of 0.97 %/ft. The CO sensor shall be of a fuel cell design and shall
meet the sensitivity requirements of Underwriter’s Laboratory’s UL
2034 single and multiple station carbon monoxide alarms. The tem
-
perature operating range shall be between 40°F and 100°F (4°C and
38°C) and the humidity operating range shall be 10% - 95% relative
humidity, non-condensing.
The combination alarm can be installed on the surface of any wall or
ceiling following the UL/NFPA/Manufacturer’s recommended place
-
ment guidelines. The alarm shall provide optional tamper resistance
that deters removal of the unit from the wall or ceiling.
The alarm shall include a test button that will electronically simulate
the presence of smoke and CO and cause the unit to go into both
modes of alarm. This sequence tests the unit’s electronics to ensure
proper operation.
The CO sensor will not alarm to levels of CO below 30 ppm and will
alarm in the following time range when exposed to the corresponding
levels of CO.
70 ppm CO Concentration 60 – 240 minutes
150 ppm CO Concentration 10 – 50 minutes
400 ppm CO Concentration 4 – 15 minutes
The combination alarm shall have two methods of warning for danger:
a piezoelectric horn that is rated at 85 decibels at 10 feet and a voice
warning that identifies the danger. For a CO incident, the horn will
sound in the repetitive manner -- four (4) fast beeps, a short pause,
four (4) fast beeps, a short pause. In between, the unit will announce
“WARNING CARBON MONOXIDE!”. In a Smoke incident, the horn will
sound in the repetitive manner -- three (3) beeps, a pause, three (3)
beeps, a pause. In between, the unit will announce “FIRE!”.
The unit shall also indicate a low battery warning utilizing each of the
following methods: a brief alarm chirp, the voice announcement of
“Low Battery!” and the red LED will flash once per minute. The unit
shall incorporate 2 LED’s. A green LED will flash every 60 seconds in
standby condition. A red LED will flash during smoke or CO alarm, and
in error mode.
Technical Specifications
Unit Number: 900-0216A
Model: KN-COSMXTR-BA
Power Source: 2 AA Batteries
Sensors: Smoke: Ionization, CO: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 10%-95% relative humidity,
non-condensing
Size: 5.6” in diameter x 1.8” depth
Weight: 13oz
Interconnects: No
Ordering Information
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788
www.Kidde.com
KL-900-0216A sheet rev. 12-2013
Distributed by:
The unit shall at a minimum meet the requirements of UL 2034,
UL217, NFPA72, (chapter 11 2002 edition) The State of California Fire
Marshall, NFPA101 (One and two family dwellings) Federal Housing
Authority (FHA), Housing and Urban Development (HUD). It shall also
include a 10-year manufacturer’s limited warranty.
5.6” 1.8”
Ordering Pack Pack Dimensions Cartons/
Number UPC I 2 of 5 Config Qty (w x d x h inches) Weight Pallet
21007450 0-47871-07450-1 100-47871-07450-8 CLAM Cut Case (4 Units) 7.94 x 9.5 x 11.75 7 75
21007833 0-47871-07450-1 200-47871-07450-5 CLAM Display (24 Units) 16.9 x 22 x 24.2 45.1 4
21008700 0-47871-08700-6 100-47871-08700-3 BOX Master Pack (6 Units) 6.25 x 13.25 x 6.25 10.75 126