Installation Guide
Part Dimensions Case/ Cartons/
Number I 2 of 5 Pack Config Pack Qty (w x d x h inches) Weight Pallet
21027488 100-47871-27488-5 Box 6 4.5 x 15.25 x 4.5 8.04 lb 200 lb
Architectural and Engineering
Specifications
The smoke alarm shall be Kidde unit i1040 or approved equal. It shall
be powered by a non-replaceable lithium battery with a 10-year life.
The lithium battery shall be sealed in the unit to prevent removal and/
or tampering. The unit shall incorporate an ionization sensor with
nominal sensitivity of 1.79% +/- 0.35%/ ft. OBS. The temperature
operating range shall be between 40°F and 100°F (4°C and 38°C) and
the humidity operating range shall be 0% - 95% relative humidity,
non-condensing.
The smoke alarm can be installed on the surface of any wall or ceiling
following the UL/Manufacturer’s approved placement guidelines.
The alarm shall incorporate an automatic activation feature that will
activate the unit as soon as it is attached to the mounting bracket, no
other steps are involved.
The alarm shall include a test button that will simulate a fire condition
and cause the unit to go into alarm. This sequence tests the unit’s
electronics to ensure proper operation.
The unit shall include a piezoelectric horn that is rated at 85 decibels
at 10 feet. The unit shall include the Hush® feature that silences
the unit for up to 8 minutes if a nuisance condition occurs. The red
LED will flash for 1 second every 8 seconds and will automatically
reset itself. If the alarm is in the Hush® mode and the condition that
triggered the alarm persists, the alarm shall sound again to signal
potential danger despite its presence in Hush® mode.The unit shall
incorporate one red LED to indicate the alarm’s current status and
mode of operation. The LED will indicate one of four modes:
Standby Mode: LED will flash every 40-45 seconds to indicate
the unit is operating correctly
Alarm Mode: LED will flash every 1.5 seconds to indicate the
unit is alarming and will be accompanied by the
horn sounding
Hush® Mode: LED will flash for 1 second every 8
seconds to indicate the unit is temporarily silenced
Memory Set Mode: If Alarm Memory has been set, the LED will
flash rapidly when the test button is pressed.
The unit will chirp once every 40-45 seconds to notify the user the
alarm needs to be replaced. The unit shall have a deactivation switch
Micro 10-Year Sealed Battery
Smoke Alarm
Model i1040
Technical Specifications
Model: i1040
UPC Number: 0-47871-27488-8
Power Source: One, 3V Lithium battery
Sensor: Ionization
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 0%-95% relative humidity (RH),
non-condensing
Size: 4” in diameter x 1.55” depth
Weight: .33 lb.
Interconnects: No
LED: Four modes of operation
Warranty: 10 year limited
to disable it and make it safe for disposal. The unit shall at a
minimum meet the requirements of UL217, NFPA72, The State of
California Fire Marshall, NFPA101 (One and two family dwellings)
Federal Housing Authority (FHA), Housing and Urban Development
(HUD).
Ordering Information
Individual UPC: 0-47871-27488-8
4.0 "
1.55 "
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788
www.kidde.com
Distributed by:
KL-i1040 sheet Rev. 08-17