Installation Guide

8
5. Introduction, Product Features And Specifications
Introduction
This alarm detects products of combustion using a multi-criteria optical sensor.
Ten (10) years after the unit was installed, this unit will automatically alert you that it is time to replace the unit.
This is called “End of Unit Life” mode. See Troubleshooting Guide. To help identify the date to replace the unit,
a label has been affixed to the side of the alarm. Write the “Install date” in the space provided, and then write
in the “Replace by” date (10 years from initial power up) in permanent marker on the label prior to installing the
unit.
Product Features and Specifications:
• Temperature Operating Range: 40°F (4.4°C) to 100°F (37.8°C)
• Humidity Operating range: up to 95% RH non-condensing
• Audible Alarm: 85+ dB at 10’, 3.0 to 3.5 KHz pulsing alarm, with voice message “Fire!”
NOTE : This is not a CO alarm, but it will receive and transmit a CO alarm signal (with voice message
“Warning! Carbon Monoxide”) from an interconnected CO or combination smoke/CO alarm.
• Smoke Sensor: Multi-Criteria Optical
• Voice message system
• Smoke Alarm SMART Hush® Control
• Powered by 120V AC (60Hz, 53mA max, 20mA avg) wire-in connector with front load 9V battery backup.
• Hardwire interconnectable to other compatible alarms.
• One large, user- friendly button.