Installation Guide

To activate the battery carrier tamper resist feature, remove the unit from the mounting bracket, disconnect the

AC quick connector and locate the small cut-out in the middle of the label on the back of the unit. With a small

screwdriver, or similar tool, slide the switch towards the “LOCK” position as

shown on the label(see Figure 9-F). The tamper resist feature is now active

and the battery carrier can not be opened until the tamper resist feature is

deactivated.

NOTE: Before activating the battery carrier tamper resist feature, make sure

a fresh battery is installed in the unit and that the battery carrier is properly

closed. If the battery carrier tamper resist feature is activated while the

battery carrier is open, the battery carrier will not close and the unit will be

inoperable during the loss of AC power.

To deactivate the battery carrier tamper resist, in order to change the smoke alarm battery, remove the unit

from the mounting bracket (see Smoke Alarm Tamper Resist Feature if activated), disconnect the AC quick

connector and locate the small cut-out in the middle of the back label. Using a screwdriver, or similar tool, slide

the switch in the opposite direction of the “LOCK” arrow as shown on the label. The battery carrier can now be

opened and the battery changed.

AC Wired Interconnect Model Capability

This model has AC hardwire interconnect capability. When one hardwired interconnect unit sounds an alarm, all

other compatible hardwire or interconnected units will also alarm.

• The following models can be interconnected using the standard AC wiring interconnect: 1235, 1275,

1276, 1285, i12020, i12020A, i12040, i12040A, i12060, i12060A, i12080, i12080A, i4618, i4618A,

i4618AC, KN-SMFM-I, RF-SM-ACDC, PE120, P12040, Pi2000, Pi2010, KN-COSM-I, KN-COSM-IB,

KN-COSM-IBA, KN-COPE-I, KN-COPE-IC, KN-COB-IC, KN-COP-IC, SL177i, SLED177i, HD135F, SM120X,

CO120X, i12010S, i12010SCO, P4010ACSCO, P4010ACSCO-W, P4010LACS-W, P4010ACS, P4010ACS-W,

2070-VASCR, 2070-VASR, P4010ACLEDS-2, P4010ACLEDSCO-2.

The alarm is now activated! After installation / activation, test your alarm as described in Operation and

Testing section.

WARNING: FAILURE TO PROPERLY INSTALL AND ACTIVATE THIS ALARM WILL PREVENT

PROPER OPERATION OF THIS ALARM AND WILL PREVENT ITS RESPONSE TO FIRE HAZARDS.

Figure 9- F