Specification
Nighthawk Carbon Monoxide Alarm
Battery Operated with Digital Display
Part Number 900-0230
Model KN-COPP-B-LP
1016 Corporate Park Drive
Mebane NC 27302
1-800-880-6788
www.kidde.com
Architectural and Engineering
Specifications
The carbon monoxide alarm shall be Kidde Model KN-COPP-
B-LP (part number 900-0230) or approved equal. It shall be
powered by three (3) AA batteries (included). The temperature
operating range shall be between 40°F and 100°F (4°C and
38°C) and the humidity operating range shall be 10% - 95%
relative humidity, non-condensing.
The CO sensor shall be of a fuel cell design and shall meet the
sensitivity requirements of Underwriters Laboratories UL2034
Single and Multiple Station Carbon Monoxide Alarms.
The alarm can be installed on the surface of any wall or table
top following the UL/Manufacturer’s recommended placement
guidelines. The alarm shall include a battery lockout system
that deters closure of battery door without batteries being
installed.
The unit shall incorporate a digital display that meets the sen-
sitivity requirements of UL 2034. The display will identify the
levels of CO in parts per million (ppm) once that level reaches
30ppm (i.e.: “abnormal” levels).
The alarm shall include a test button that will electronically
simulate the presence of CO and cause the unit to go into
alarm. This sequence tests the unit’s electronics to ensure
proper operation. Per UL 2034 requirements, the CO sensor
will not alarm to levels of CO below 30 ppm and will alarm in
the following time range when exposed to the corresponding
levels of CO.
70 ppm CO concentration 60 – 240 minutes
150 ppm CO concentration 10 – 50 minutes
400 ppm CO concentration 4 – 15 minutes
The unit shall incorporate 2 LED’s. A green LED will flash once
every 30 seconds to indicate the alarm is operating properly
when power is present. A red LED will pulse to indicate carbon
monoxide has been detected until the device is reset or CO is
eliminated.
Technical Specifications
Part Number: 900-0230
Model: KN-COPP-B-LP
Power Source: 3 AA BATTERIES
Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
non-condendsing
Humidity Range: 10%-95% relative humidity (RH)
Size: 3.0” x 5.0” x 1.5”
Weight: .44 lbs with battery
Interconnects: No
Warranty: 10 year limited
Ordering Information
Clamshell UPC: 0-47871-07267-5
*Based on accuracy claims of major manufacturers
See user guide for additional important information.
**Not for sale by individual unit
Distributed by:
KL-900-0230 sheet rev. 09-2015
!
WARNING: This product is intended for use in ordinary indoor
locations of family living units. It is not designed to measure compli-
ance with Occupational Safety and Health Administration (OSHA)
commercial or industrial standards.
This device is designed to protect individuals from acute effects of
Carbon Monoxide exposure. It will not fully safeguard individu-
als with specic medical conditions. If in doubt, consult a medical
practitioner. Individuals with medical problems may consider using
warning devices which provide audible and visual signals for carbon
monoxide concentrations under 30 ppm.
Industry experts recommend a CO alarm be installed on each level
of the home--ideally on any level with fuel burning appliances and
outside of sleeping areas.– see User Guide for further information.
Part Dimensions Case/ Skid
Number I 2 of 5 Pack Quantity (w x d x h inches) Weight Skid Weight
900-0230** N/A Individual (Clam) 7.5 x 2 x 11 1.25 lbs. N/A N/A
21007267 100-47871-07267-2 Cutcase (4 units) Clam 7.94 x 11.5 x 11.25 5 lbs. 60 300
21007333 200-47871-07267-9 Cutcase (8 units) Clam 7.94 x 21.63 x 11.5 10 lbs. 36 360