Use and Care Manual

NOTE: Use standard UL Listed household wire (as required by local codes) available at all electrical supply

stores and most hardware stores.

NOTE: AC power should be turned off at this stage.

• After selecting the proper location for your Alarm, and wiring the AC

QUICK CONNECT harness as described in the WIRING INSTRUCTIONS,

attach the mounting bracket to the electrical box. To ensure aesthetic

alignment of the alarm with the hallway, or wall, the “A” line on the

mounting bracket must be parallel with the hallway when ceiling mount-

ed, or horizontal when wall mounted.

• Pull the AC QUICK CONNECTOR through the center hole in the mounting

bracket and secure the bracket, making sure that the mounting screws are

positioned in the small ends of the keyholes before tightening the screws.

Additional

Alarm

REDBLACK

WHITE

Additional

Alarm

RED

BLACK

WHITE

FUSE OR CIRCUIT BREAKER

REDBLACK

WHITE

Kidde Relay Module

SM120X, CO120X

or both

Optional

Accessory

First

Alarm

Figure 10-A, Interconnect Wiring Diagram

Existing Kidde

AC Connector

(either connector

can be used for

this model)

AC connector

shipped with

product

AC connector

Wires on alarm harness: Connected to:

Black: Hot side of AC line

White: Neutral side of AC line

Red: Interconnect lines (red wires) of other

units in the multiple station set-up

Figure 10-B