Use and Care Manual

• Loud 85 decibel alarm.

• Permanent independent smoke and carbon monoxide sensors.

• Powered by 120V AC (60 Hz, 45mA max) wire-in connector .

• Interconnectable to other Kidde/Nighthawk brand smoke and

CO alarms (see page 15 for details).

SMOKE ALARM: The alarm pattern is three long alarm beeps,

which will repeat until the smoke is eliminated. The red LED

light will flash during alarm.

LOW BATTERY: If the battery is low, the red LED light will flash

and the unit will “chirp” one time, for a minimum of seven (7)

days. This alarm contains a sealed 3V Lithium battery, which

will last the life of the alarm. No need to replace batteries.

• End of Life Hush. At end of product life, the button can be

pushed to silence the end of life "chirp" for approximately

3 days at a time, for a maximum of 30 days life extension.

• One “chirp” every 30 seconds coupled with a green LED flash

twice a second is an indication that the alarm is

malfunctioning. If this occurs call the Product Support Line at

1-800-880-6788.

• Test/Reset button performs functions.(See page 14).

• HUSH Control Feature that silences the unit during nuisance

alarm situations (see page 15).

• Alarm Memory Feature that gives visual indication when an

alarm has sensed a hazardous condition.

• Green and red LED lights that indicate normal operation and

alarm status (see page 17 for details).

The smoke alarm monitors the air for products of combustion

that are produced when something is burning or smoldering.

When smoke particles in the smoke sensor reach a specified

concentration, the alarm warning system will sound, and be

accompanied by the flashing red LED light.

WARNING: PLEASE READ CAREFULLY AND

THOROUGHLY

NFPA 72 states: Life safety from fire in residential occupancies is

based primarily on early notification to occupants of the need to

Features

1210-7201-00(i12010S)_V6a.qxd:_ 2013.11.28 9:55 AM Page