Use and Care Manual

17
Battery Information
Alarm Removal
IF TAMPER RESIST FEATURE HAS BEEN ACTIVATED, REFER
TO TAMPER RESIST FEATURE DESCRIPTION ON PAGE 17 FOR
REMOVAL INSTRUCTIONS.
Remove the alarm from the mounting bracket by rotating the
alarm in the direction of the “OFF” arrow on the cover.
Battery (Non-Replaceable)
If any form of battery failure is detected the red LED light will
flash and the unit will “chirp” one time, followed by the warning
message “LOW BATTERY”. This alarm contains a sealed 3V
Lithium battery, which will last the life of the alarm. No need to
replace batteries. This cycle will occur once every minute, and will
continue for at least seven days. Replace alarm immediately!
THE UNIT MUST BE DEACTIVATED (see “Deactivation of
Alarm” section) and replaced within 7 days of the first
occurrence of the “Low Battery Warning” to provide
continuous alarm protection.
If the red LED light flashes along with a chirp every 30
seconds, as described above, and if the green LED flashes
twice per second (AC power only) your unit has
malfunctioned.
Call our toll free Product Support Line at
1-800-880-6788 for instructions on how to return the unit.
End of Life Notification
Ten (10) years after unit is first powered, this alarm will beep two
times every 30 seconds to indicate it is time to replace the alarm.
REPLACE IMMEDIATELY!
End of Life Hush can be activated by pushing the test
button to silence the End of Life chirp for approximately
3 days at a time for a maximum of 30 day life extension.
1210-7201-00(i12010S)_V6a.qxd:_ 2013.11.28 9:55 AM Page