Use and Care Manual

8
9
Operating Instructions
Mode What to do What to expect
Create Account Download and install app RemoteLync App should be on your mobile device
Connect to
Wireless Router
Following instructions in app, connect to
monitor
You should connect to the Kidde monitor through Wi-FI. The
monitor will report back what routers are with in range for you to
select and provide passcode to inorder for monitor to connect.
Enroll Monitor to
account
Once monitor is connected to wireless
router, press button on monitor then tap
"enroll my monitor" in app
Once monitor is connected to your router, you will add it to your
account. Besure you are connected to the same Wi-Fi router as
the monitor for enrollment to work.
Learn Alarms in
home
With monitor connected to wireless router
and monitor enrolled to you account, setup
monitor with the alarms in your home
furthest from the monitor
With the monitor in setup mode you will test the smoke and/or
CO alarms furthest from the monitor so it can judge the volume
it will hear alarms at. This helps reduce false detections from
your neighbours house or appartment.
Test monitor Test your monitor (self-test) and that it is
functioning properly with the alarms in
your home.
App will show testing progress. It will indicate if self-test
completed successfully and whether or not it detected an alarm
pattern from your alarms if they were tested.
Alarm Detected Through the app, notify your contacts to
check on the situation if you are not able.
When an alarm pattern is detected, monitor will send out
notifications to you and your contacts you have added for this
monitor.
Add new Monitor Open your app and using the “add”
function, setup the monitor as was done on
previous monitor(s). Name monitor to be
sure you can identify the differnet locations.
Follow the same processes as above for connecting to wireless
router, enrolling into account and learning alarm furthest from
monitor.
Change Monitor
Location
Using the “setup alarms with monitor from
the menu in the app, follow the instruction
and test alarm furthest from monitor when
instructed.
App will walk you through the process to re-establish detection
of your alarms.
Change/Reset
Router
Go into app and follow instructions to
connect moniotr to wi-fi.
You will go through the same process of “connecting to wireless
router” as was done at setup.
Un-Enroll Monitor Remove monitor from your account Go into monitor menu and remove monitor from account if you
no longer have the monitor.
Operation table for app